Easy lifehacks

Why do my lights flicker when I turn on my car?

Why do my lights flicker when I turn on my car? The most common reason for flickering lights is a worn out alternator, as one of the three rotating plates that generate electricity wears out. So as the unit hits the "dead spot," the power wanes, causing the lights to flicker. Replace the alternator if it fails to produce more than 13 volts, or tests bad. Why are the lights on my instrument cluster not working? 2006 infiniti qx56 – rpm not working, some of the dash lights not lit, when I turn headlights on or day light running lights...
Easy lifehacks

How much horsepower does a stock 2005 Duramax have?

How much horsepower does a stock 2005 Duramax have? LLY Duramax Specifications ChartManufactured Years:2004-2006Fuel Tank Size:Short Beds: 26 Gallons Long Beds: 34 GallonsMax Engine Speed:3,250 RPMHorsepower:310 horsepowerTorque:2004 & 2005: 520 lb/ft @ 1,600 rpms 2006: 605 lb/ft @ 1,600 rpms When did the Duramax 6.6L V8 come out? lb7: 2001-2004 The LB7 is the original production 6.6L Duramax V8. Following success with the performance and reliability of the LB7, this engine became the building block of the Duramax line all the way up until today. How big is a LLY Duramax diesel engine? LLY Duramax Specifications Chart Manufactured Years: 2004-2006...
Most popular

When should I switch my heat pump to emergency heat?

When should I switch my heat pump to emergency heat? It is used when there is something wrong with first-stage heating (the Heat Pump itself). In other words, if you notice your house is cold and it isn't heating properly and you went outside and noticed that a tree fell and crushed your heat pump, that would be a good time to switch to Emergency Heat. What is the best temp to set heat on? 68 degrees Fahrenheit According to ENERGY STAR, setting your thermostat to 68 degrees Fahrenheit (20 degrees Celsius) when you're home is the ideal balance of...
Other

Can a bad sensor cause a check engine light?

Can a bad sensor cause a check engine light? Depending on your vehicle model, your engine might experience one or more of these performance problems: However, these symptoms are not exclusively symptoms of a failed MAP sensor. Sometimes, a bad sensor may trigger the check engine light (CEL). What causes a bad O2 sensor on a Chevy Silverado? While a rough running engine can be a sign of a bad oxygen sensor, it is often a sign of a misfire as well. Often enough, there won’t be any noticeable signs of a bad oxygen sensor. You’ll go to get an...
Common questions

Did you join or joined?

Did you join or joined? Did you join is a simple past tense . We use simple past to talk about completed actions, state or possession. Have you joined is s present perfect tense. Which is correct joined or joined? First one “I have joined” is in Present Perfect Tense. And second sentence “I had joined” is in Past Perfect Tense. Both are correct so long as they're used in the right context. I have joined - present tense. What is the tag question of good morning? There is no tag in that sentence. An example of that sentence coupled...
Easy tips

What causes a cylinder to misfire at idle speed?

What causes a cylinder to misfire at idle speed? Ignition Misfires Photo 2: To prevent cylinder misfires at idle speed, some ignition systems fire each spark plug twice, producing a “double-strike” waveform. Intermittent ignition misfires can be caused by faulty spark plugs, spark plug wires, ignition coils and ignition coil drivers located in the ECM. What causes a car to have a misfire? Nothing gets your attention like an unexpected change in the performance of your vehicle’s engine. A misfire will cause the engine to momentarily stumble, or lose rpms, and then regain its normal engine speed. The misfire will...
Other

Are there any problems with the 2004 Chevy Malibu?

Are there any problems with the 2004 Chevy Malibu? Worst 2004 Chevrolet Malibu Problems #1: Power Steering Going Out Intermittently 2004 Malibu Average Cost to Fix: $700 Average Mileage: 81,000 mi. Learn More #2: Steering Column Is Defective 2004... When did the first Chevy Malibu come out? One of the oldest nameplates in the auto industry, the Chevrolet Malibu first appeared in 1964. Several generations followed until 1983, when the Malibu went on hiatus until 1997. Always a mid-size car, the Malibu has become alternately larger and smaller with the times, always remaining popular with families. Can you take the...
Easy tips

What does no link mean on OBD2 Scanner?

What does no link mean on OBD2 Scanner? These issues include an incompatible obd2 scan tool, bad fuses, damage in the circuit board, ECU, and failed computer. ... Why is my Car code reader not working? The code reader will then power up and display the welcome screen. If the screen does not come on wiggle the reader connector while in ALDL data port. Sometimes the pins can become a little corroded because of moisture which will make the connection questionable. How do you connect a code reader to a car? Let's Get Started! Begin with the vehicle's engine off...
Most popular

What kind of test can I do on a GM car?

What kind of test can I do on a GM car? With the tests in this article, you'll be able to test and diagnose: A bad ignition control module, or a bad ignition coil, or a bad distributor cap, or bad spark plug wires. For a complete list of GM vehicles these tests apply to, take a look at the bottom of the page. What kind of problem does a 1997 GMC pick up have? 1997 GMC K1500, K2500, K3500 Pick Up. All of the information you need to diagnose a misfire or a no-start problem (caused by the ignition...
Other

Why are the stability control and traction control warning lights flashing?

Why are the stability control and traction control warning lights flashing? The stability control and traction control warning lights can trigger for several reasons. The first step you will want to take will be to have the vehicle scanned for diagnostic troubleshooting codes. This will tell you what about the systems is malfunctioning. When does traction control turn off Service StabiliTrak? The “Service Stabilitrak” light will usually appear first and then the car will turn traction control off. Once traction control is turned off, the transmission beings to shift very hard and rough. When does the traction control light come...