Easy tips

What causes a 2012 Dodge Ram 1500 to stall?

What causes a 2012 Dodge Ram 1500 to stall? The contact owns a 2012 Ram 1500. While driving approximately 40 mph, the vehicle suddenly stalled and was towed to stalling Dodge (1245 38th blvd ne, cairo, ga). The cause of the failure was not determined. The manufacturer was not notified of the failure. The failure mileage was 92,000. Loud ticking noise caused by lifter/camshaft malfunction. Why is the Check Engine light on on my Ram truck? Go to the truck and find the check engine light is on. Bought a code reader to find out why the check engine light...
Common questions

Do you need to grease spark plugs?

Do you need to grease spark plugs? It's very important not to over or under tighten spark plugs during installation. If your engine has the more modern 'COP' system (coil-on-plug) then lube the spark plug boot with dielectric grease, this helps prevent misfires and makes removing easier in the future. Can you install spark plugs wrong? Incorrectly removing or installing spark plugs can cause damage to your engine. It's possible to damage the threads inside the engine when installing the spark plug. Can Vaseline be used instead of dielectric grease? Vaseline can work as a substitute for dielectric grease, the...
Most popular

Why is my transmission slamming gears?

Why is my transmission slamming gears? When the transmission bangs into gear, it is usually due to either the engine or transmission mounts. When the mounts are worn out, they allow excessive movement that is noticed when switching between drive, park, neutral, and reverse at idle. Is there an issue with 4th gear shifting? There is an issue with my transmission when I get on it hard when shifting from 3rd to 4th, then 4th to 5th. What causes a manual transmission to shift hard? Generally transmission hard shift might to do with the issues in gear system or with...
Easy lifehacks

When to know if your car is hard to start?

When to know if your car is hard to start? At one time or another, the starter motors will wear out and suffer a breakdown. You should check the starter when absolutely nothing happens after turning the ignition switch, or the car turns over slowly with faint dash lights. 5. Failing Solenoid How to pick yourself up when you are down? You are well and truly down. Having the ability to pick yourself up during hard times is an essential skill that you need to develop. You must have ways where you can lift yourself up so that you can...
Easy lifehacks

Where is the radio fuse in a 2012 Dodge Journey?

Where is the radio fuse in a 2012 Dodge Journey? The interior fuse panel is located on the passenger side under the instrument panel. How do you turn on the radio in a Dodge Journey? Push the ON/OFF Volume Control knob to turn on the radio. Push the ON/OFF Volume Control knob a second time to turn off the radio. Is the Dodge Journey compatible with Sirius Radio? Journey: I have a 2012 Dodge Journey complete with Sirius Radio. I have a 2012 Dodge Journey complete with Sirius Radio. I have recently been told by sirius customer service that my...
Other

What to do when check engine light comes on?

What to do when check engine light comes on? The whole purpose behind the Check Engine or Service Engine Soon light is to alert you to a minor problem before it becomes a bigger issue. While you don’t need to immediately pull off the road and have your vehicle towed when this light comes on, you should schedule an appointment to have it fixed right away. Why is my Check Engine light still on after filling up? The cap is a crucial part of a car’s fuel delivery system. It notably prevents gasoline fumes from leaving the fuel tank, and...
Easy lifehacks

How are brake and turn signals combined on a trailer?

How are brake and turn signals combined on a trailer? The brake and turn signals are combined on a trailer, so it would be odd if it was just the brake light giving you issues. Either way, I would check to make sure the ground on the light assembly itself is securely attached to a clean, bare metal surface - whether it ground through a dedicated wire or through its mounting hardware. Why is my harness not connecting to my trailer? Ground location for harness or trailer connector is weak or ground connection has loosened over time. Harness has been...
Easy tips

What kind of steering stabilizer do I need for my Dodge Ram 3500?

What kind of steering stabilizer do I need for my Dodge Ram 3500? The BD-Power 1032004 Steering Box Stabilizer (SBS) eliminates steering wander and wobble in your 1994-2002 Dodge Ram 2500/3500 4WD. Most steering issues are caused by excessive shaft play in the steering box of your Dodge Pickup. What kind of steering do I need for a 1998 Dodge Ram? The MOOG DS1458 Left Inner Tie Rod for your 98-99 Dodge Ram 2500 4WD incorporates proven design and engineering features for like new steering, ease of installation and longer life. MOOG is the preferred steering and suspension parts brand...
Easy tips

Is the fuel pressure relief valve on a Cummins 5.9?

Is the fuel pressure relief valve on a Cummins 5.9? It’s a pretty common failure, and luckily a new FCA is very easy to install on a Cummins, and it’s also affordable at a hundred and thirty bucks. One other part on a common-rail 5.9 that’s known to fail would be the Fuel Pressure Relief valve. What kind of transmission does a Dodge 5.9L Cummins use? ATS will not pay for any fluids replaced in the event of a transmission failure. The BD-Power 48RE Transmission and Converter Package is what your 2003-2007 Dodge 5.9l Cummins factory transmission needs to handle...
Other

What causes a broken clock spring?

What causes a broken clock spring? Clocksprings wear in time or become damaged during repairs to the steering column, or when removing a rack and pinion gear, gearbox, or coupling. If the steering wheel is allowed to spin freely, the clockspring's connection may break, resulting in an open circuit and an illuminated airbag light. Can a broken clock spring reset an airbag light? So as it turns out, even if one of the airbags has an open circuit code from a broken clock spring and throws a hard code, you do not have to use a handheld scan tool to...