MSI

How much does it cost to replace a rear brake cable? To replace a rear cable, the labor time is around 1.1 hours, and the cost of a factory cable is about $141. The cost range for aftermarket cables is about $17 to $34. This makes the job to replace a rear cable cost about $251 using OE parts, and from about $127 to $143 using aftermarket parts. How much does it cost to replace the emergency brake cable on a Tacoma? This makes the emergency brake repair cost about $187. To replace an e-brake cable on the Tacoma, there...

What should I do if my starter shaft loosens? Wrap the pinion gear with a rag and hold it with pliers if needed to keep it from turning when the bolt is loosened. Remove the jack shaft bolt and washers. Remove the pinion gear and spring, and check for any damaged teeth on the starter driven gear on the clutch basket. How does the Bendix gear on a starter motor work? This video is all about the Bendix gear on a starter motor. This is the gear that rises up and engages with the ring gear around the flywheel. When...

What do you need to know about p20ba reductant heater? P20BA - Reductant Heater A Control Performance Description:The powertrain control module (PCM) carries out a functional key ON, enginerunning (KOER) self-test for the glow plug system. How to reset 120 day RDS grace period on 2012 R2? I like doing posts which shows some cool hacks, and this is exactly this kind of post – How To Reset 120 Day RDS Grace Period on 2012 R2 Server. Normally you would need to activate the RDS/TS CAL License server and point the Server to License server with User/Device License and will...

Is there a backup camera on my 2014 Escape? My 2014 Escape rear... My 2014 Escape rear backup camera is intermittently posting a message that camera is unavailable when I am backing up slowly. Sometimes it operates normal but more times it is not. Mechanic's Assistant:Is this an aftermarket camera, or did it come with the vehicle? Where is the rearview camera on a Ford Escape? Both "Early" and "Late" apparently use the same camera. IF you have and replace the IPBM, THEN programming of that replaced module is required. IF you have it the IPBM is located behind the...