Most popular

What happens when you touch 86 and 85 on a relay?

What happens when you touch 86 and 85 on a relay? When you touch 86 and 85 to the battery, the electromagnet pulls the switch contacts together, so the resistance between 30 and 87 should read essentially zero (under one ohm). If it doesn’t, the relay isn’t working. Why does my Hagerty relay not show continuity? If the relay does click and 30 and 87 do show continuity, there is still the possibility that the internal contacts are corroded and a voltage drop across them is preventing full current from flowing. Take that thought and park it for a moment....
Easy tips

What can make a PT Cruiser overheat?

What can make a PT Cruiser overheat? While there are a variety of reasons your Chrysler PT Cruiser is overheating, the most common 3 are a coolant leak (water pump, radiator, hose etc.), the radiator fan, or a failed thermostat. Where can I get genuine Chrysler PT Cruiser parts? Genuine Chrysler Pt Cruiser Parts from Factory Chrysler Parts in Bartow, FL. Chrysler OEM Pt Cruiser Parts from Thunder CDJR. Genuine Chrysler parts are the smart choice for repair, maintenance, or upgrade of your Chrysler Pt Cruiser . What kind of engine does a PT Cruiser have? The base engine for...
Easy lifehacks

What do I do when my car is overheating on the freeway?

What do I do when my car is overheating on the freeway? Try revving the engine. If you’re in bumper-to-bumper traffic, shift into park or neutral and tap the accelerator to rev the engine. This will speed up the process under the hood and get more water and air to the radiator to cool things off. What should I do if my Mercedes is overheating? If you are able to top off the coolant, or use a bottle of water for now, it may help bring your car out of its heat spell. After you have pulled over, and if...
Common questions

What does the ESC light stand for on a car?

What does the ESC light stand for on a car? The ESC light stands for the electric stability control light. This system works hand in hand with your vehicle’s traction control system to help you control your vehicle in dangerous conditions. But while stability control and traction control are often referred to together – they are not the same system. Is it safe to drive with the ESC light on? Is it safe to drive with the ESC light on? While electronic stability control can help you avoid loss of control of the vehicle, it can’t do everything for you....
Easy lifehacks

Is the blend door actuator working with rear passenger vents?

Is the blend door actuator working with rear passenger vents? To my surprise, this appears to be working with the front passenger vents, however it isn't with the rear. Do you guys maybe know other tricks, as this indeed looks like a software issue. How can I tell if my blend door actuator is bad? To test the blend door operation and too double check that you are changing the correct actuator motor turn the blower motor on and work the door in each way. You will be able to feel the air change temperature or vent level. Compare the...
Easy tips

Can a car battery be bad but test good?

Can a car battery be bad but test good? As long as battery voltage remains above 9.6 volts, the battery is considered “good.” But if it drops below 9.6 volts by the end of the test, the battery may be “bad,” or the battery may have to be recharged and retested if it was not fully charged prior to the test. What causes a car battery to not hold a charge? 2. A problem with your battery is causing it to not hold a charge. To check this, wait 12 to 24 hours after charging to the full voltage, keep...
Easy tips

Why does my starter solenoid not have power?

Why does my starter solenoid not have power? Yes, when the ignition switch is in the START position, the small wire on the solenoid should have power. That's why I think your problem is in the ignition switch. If the ignition switch isn't making contact in the START position, the solenoid wouldn't get any power. When does the power wire go to the starter? The other goes to the starter and is only hot when the solenoid is engaged, which is when the key is turned to the START position. The small wire is the power wire that energizes the...
Easy tips

Why does my car have a low voltage p0562 code?

Why does my car have a low voltage p0562 code? The P0562 code means that the engine control unit recognizes a voltage of under 10 volts for 1 minute when the engine is running in the electric system. Common causes are low charging from the alternator or a bad car battery. It can also be caused by bad wirings. Why do I need to lock up the torque converter? The TCC System uses a solenoid-operated valve to couple the engine flywheel to the output shaft of the transmission through the torque converter. Lockup reduces slippage in the converter increasing fuel...
Common questions

Can my 10 year old son stay home alone?

Can my 10 year old son stay home alone? 8 to 10 Years - Should not be left alone for more than 1½ hours and only during daylight and early evening hours. 11 to 12 Years - May be left alone for up to 3 hours but not late at night or in circumstances requiring inappropriate responsibility. 13 to 15 Years - May be left unsupervised, but not overnight. How old does a child have to be to be left home alone? Children under six years of age are never left alone without adequate supervision. Children six through seven years...
Easy lifehacks

How do you advocate for children at risk?

How do you advocate for children at risk? Child Abuse Hotline: 1-800-387-5437 (KIDS) to get help if you, or children you know, are being neglected, abused or sexually exploited. If you believe a child is at risk, you must report it. Help is available in multiple languages 24/7. What is advocating for a child? Child advocacy is support for children who are in a vulnerable position in society or a vulnerable situation. So, we advocate by speaking on someone's behalf, in this case, a child. So, a teacher, a parent, a psychologist, a physical therapist, a trainer, etc. can advocate...