Is the blower motor resistor on my F 150 still working?

Replaced the blower motor resistor and the fan still will not work – where is the blower mtor in my 2010 F 150 so I can – Answered by a verified Ford Mechanic We use cookies to give you the best possible experience on our website.

How to replace a blower motor in a Ford?

Use only the correct blower motor listed for the specific vehicle application in the Ford Catalog Advantage(TM) or equivalent. 1. Remove the junction box cover. 2. Disconnect the blower motor electrical connector. 3. Remove the 3 blower motor screws. 4. Remove the blower motor. 5. To install, reverse the removal procedure.

Why does my Ford F 150 fan not work?

Replaced the blower motor resistor and the fan still will not work – where is the blower mtor in my 2010 F 150 so I can Replaced the blower motor resistor and the fan still will not work – where is the blower mtor in my 2010 F 150 so I can – Answered by a verified Ford Mechanic

Can a dual zone eMTC blower motor be interchangeable?

NOTICE: The blower motors for vehicles equipped with dual-zone Electronic Automatic Temperature Control (EATC) and vehicles equipped with Electronic Manual Temperature Control (EMTC) are not interchangeable. If the wrong blower motor is installed for the specific vehicle application, the blower motor circuit components will be damaged.

Why is my blower motor resistor not working?

CLICK HERE TO RESET YOUR PASSWORD! Help! Fan quit working on all 4 speeds. AC light & recirc light still light up and AC compressor clutch engages when turning fan on in AC mode, but not getting the fan to work. I replaced the blower motor resistor and the control unit with new parts from rockauto (ACDelco).

What happens when a heater motor resistor fails?

If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored. 2. Blower motor does not work on certain settings

Where is the relay on a blower motor?

Correction assuming 97 is same (probably is)… Fan relay is as posted before on top of the duct work left of the resistors you can see both behind the glove box if you take it out. The purple wire comes from the relay/resistors according to fan speed selected.

When do you replace the fan control AMP?

If that checks out replace the blower motor. If you don’t see a change in voltage on terminal 2 of the blower motor when adjusting the fan control knob than check for power on terminal 2 of the fan control amp and for ground on terminal 1. If you have power and ground replace the fan control amp.

What causes a blower motor to stop working?

In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. Blower motors generally don’t fail out of the clear blue.

Why is the blower motor on my 2010 F150 not working?

The blower motor on my 2010 F150 is not working. At first I checked the fuses they are good. I moved the wiring around Have Ford questions? Ask a mechanic for answers ASAP By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them.

What to do if your blower fan is not working?

Blower Motor Resistor Replacement – YouTube Blower fan not working – 2004-2014 Ford F-150 and other models. Blower Motor Resistor Replacement If playback doesn’t begin shortly, try restarting your device.

What happens when a blower motor resistor fails?

If you’ve replaced a blower motor resistor and that replacement has failed, it’s time to conduct an amperage test on the blower motor. If the amp draw exceeds manufacturer’s specifications, replace the blower motor. can also cause an overheating condition. In some cases, the heat is so high that it melts the connector.

Is the blower motor resistor on my F 150 still working?