How do you get scratches out of car interior plastic?

How do you get scratches out of car interior plastic?

The Process

1. Step 1: Clean the area on and around the scratch with interior plastic cleaner.
2. Step 2: Using a heat gun (at around half power), gently apply heat to the plastic until it begins to soften.
3. Step 3: Apply a grain pad to the affected area, using very light pressure.
4. Step 4: Let the area cool and harden.

How do you open the trunk on a 2009 Honda CRV?

To open the trunk, press the trunk release button on the driver’s door. You can also use the master key to open the trunk lock. To close the trunk, press down on the trunk lid. Do not press down on the rear spoiler as you may damage it.

How to remove the rear side trim panel?

Remove the rear side trim panel (A). -1 Open the lid (B) and remove the screw (C), then remove the cargo hook (D).-2 Release the hooks (E), then remove the jack cover (F).-3 Remove the clip (G), then pull the trim panel back by hand to detach the clips (H, I).-4 Release the hooks (J) from the C-pillar trim (K)…

What to remove from the rear of a Honda?

Put on gloves to protect your hands. Take care not to bend or scratch the trim and panels. Use the appropriate tool from the KTC trim tool set to avoid damage when prying components. Remove these items: Rear door sill trim Cargo area floor mat, cargo floor lid, cargo storage bin Rear trim panel Tie-down hooks

How to remove interior panels from your car?

Removing interior panels in your vehicle is easy when you use a fine touch and proper tools. Learn small tricks to removing any panel in your car or truck. EDM Detection Mode by Kevin MacLeod is licensed under a Creative Commons Attribution license ( https://creativecommons.org/licenses/…) Source: http://incompetech.com/music/royalty-…

How to remove the trim from a car?

19 Refitting is a reversal of removal, but tighten the seat belt anchor bolts to the specified torque. 20 Remove the rear seat belt upper anchorage. 21 Fold down the rear seat back. 22 Extract the five securing screws and remove the trim panel (see illustration).

Remove the rear side trim panel (A). -1 Open the lid (B) and remove the screw (C), then remove the cargo hook (D).-2 Release the hooks (E), then remove the jack cover (F).-3 Remove the clip (G), then pull the trim panel back by hand to detach the clips (H, I).-4 Release the hooks (J) from the C-pillar trim (K)…

Put on gloves to protect your hands. Take care not to bend or scratch the trim and panels. Use the appropriate tool from the KTC trim tool set to avoid damage when prying components. Remove these items: Rear door sill trim Cargo area floor mat, cargo floor lid, cargo storage bin Rear trim panel Tie-down hooks

How to remove the interior panels on a Honda?

Install the panel in the reverse order of removal, and note these items: Check the clips for damage or stress-whitening, and replace them with new one. Make sure there are no twists or kinks in the seat belt. Push the clips and hooks into place securely. Well I hope this was what your looking for if not im sure i can get you what you need

How to remove interior trim panel on Pelican?

Rear Side Panel: On the rear of the panel remove the small plastic access cover and then remove the single T20 Torx screw (red arrow). Rear Side Panel: Begin pulling the panel away from the side. Once you have access to the back of the panel reach in and disconnect the connection for the speaker (red arrow).