What to do if the sunroof does not work?
What to do if the sunroof does not work?
NOTE: If at any point during the following procedure the sunroof does not respond as expected, restart the procedure at Step 1. 1) Depress and hold the CLOSE push button of the sunroof switch until the sliding glass panel is fully closed. 2) Continue to hold the CLOSE push button of the sunroof switch.
What happens when you close the sunroof on a car?
When holding down the close button, the sunroof should cycle through the open, closed and vent positions on its own. Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died.
How to calibrate a Dodge Challenger sun roof?
This procedure has worked for JGC and Charger/300/Challenger/Magnum owners. Its for when the sunroof is closing too high or low. Steps 1-6 are for using a Starscan thus starting with #7. 7. Place the ignition switch in RUN position. 8. Close all of the doors. 9. Press and release the vent switch (sunroof should move to vent position). 10.
Is there a problem with the sun roof calibration?
Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position.
NOTE: If at any point during the following procedure the sunroof does not respond as expected, restart the procedure at Step 1. 1) Depress and hold the CLOSE push button of the sunroof switch until the sliding glass panel is fully closed. 2) Continue to hold the CLOSE push button of the sunroof switch.
When holding down the close button, the sunroof should cycle through the open, closed and vent positions on its own. Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died.
Why is the sunroof higher than the roof?
If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position. So I try to open the sunroof and then close it so it will be in the position where the rear edge is more flush to the roof.
Why does my sunroof leak when it rains?
After driving it I then notice that the rear edge of the sunroof seems to have move up too much and appears to be in the same raised rear edge position as if I had closed it from the vent position. If I park the vehicle level or nose down and it rains it leaks from the rear center section of the seal.
If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position. So I try to open the sunroof and then close it so it will be in the position where the rear edge is more flush to the roof.
After driving it I then notice that the rear edge of the sunroof seems to have move up too much and appears to be in the same raised rear edge position as if I had closed it from the vent position. If I park the vehicle level or nose down and it rains it leaks from the rear center section of the seal.
This procedure has worked for JGC and Charger/300/Challenger/Magnum owners. Its for when the sunroof is closing too high or low. Steps 1-6 are for using a Starscan thus starting with #7. 7. Place the ignition switch in RUN position. 8. Close all of the doors. 9. Press and release the vent switch (sunroof should move to vent position). 10.
Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position.
