What kind of steering does a Massey Ferguson have?
What kind of steering does a Massey Ferguson have?
It power steers to the left but not to the right. The manual steering is ok. The previous owner spent a bunch on money trying to get it fixed, including a new pump yet it’s still broke. Any Ideas?
Why is my power steering not working on my Tractor?
The valve has sliding parts that are a lapped fit with no seals. When the valve wears fluid seeps out between the spool and the body. The steering still works but you lose all the fluid and then have no power steering.. Your foot is also wet with fluid.
How to fix steering problems on a Massey Ferguson 135?
: WE HAVE A 165 THAT HAD A SIMILAR PROBLEM AND I WAS ABLE TO GO TO THE STEERING CYLINDER IN THE FRONT AND ADJUST A NUT ON TOP OF THE CYLINDER THAT AFFECTED HOW MUCH THE STEERING UNIT TURNED IT ONLY TOOK A LITTLE BIT AND IT WORKS FINE, THE NUT IF I REMEMBER RIGHT WAS ON THE TOP ON A SMALL BENT LINKAGE ROD . HOPE THIS HELPS
What happens when power steering valve wears out?
The valve has sliding parts that are a lapped fit with no seals. When the valve wears fluid seeps out between the spool and the body. The steering still works but you lose all the fluid and then have no power steering.. Your foot is also wet with fluid. I figure out a fix in stead of buying the $700 if you can get one power steering valve.
Why is my power steering not working on my Massey Ferguson?
As it turned out, the power steering system was low on fluid even though the reservoir initially looked as if it had plenty. There was a diesel fuel leak where 2 return lines joined and went back into the fuel tank. The key switch also did not work, and after some wire tracing and a little checking with a multi-meter those issues got resolved too.
How can I Fix my Massey 65 power steering?
Massey 65 – Power Steering Bleeding Help.. I just rebuilt the power steering cylinder (due to leaky seal on the end). Cleaned up the pedestal and all linkage. The tractor had been sitting in garge while I did all this for about 2 months – so system was bone dry. I had disconnected all the lines and painted everything up.
Why is my power steering on my Tractor?
Very slight movement – 1/16″ or less. That movement is all it takes to energize the power steering. You will also see slop in the pins connecting the linkage, possibly the turnbuckle itself is flopping.
The valve has sliding parts that are a lapped fit with no seals. When the valve wears fluid seeps out between the spool and the body. The steering still works but you lose all the fluid and then have no power steering.. Your foot is also wet with fluid. I figure out a fix in stead of buying the $700 if you can get one power steering valve.
