Is the Kobelco sk350lc-8 bad start?
Is the Kobelco sk350lc-8 bad start?
Q: my Kobelco SK350LC-8 bad start, ignition from the display of a pump two pump 200-300 pounds pressure jump is not burning, is not a pressure car lead to start ah! Where is the problem, the display does not have any alarm?.
Can a Kobelco sk200-8 hold off a car to walk?
Q: Kobelco SK200-8 will hold off the car to walk. A: (1) the hydraulic pump and its control system are out of order, test the P1 and P2 pump pressure, the normal value should be 32-34M. (2) test the pressure of the pilot circuit, the pressure is always around 3.0M.
What should the pressure be on a Kobelco excavator?
A: (1) the hydraulic pump and its control system are out of order, test the P1 and P2 pump pressure, the normal value should be 32-34M. (2) test the pressure of the pilot circuit, the pressure is always around 3.0M. (3) check whether the valve and the valve seat of the walking system are worn or not. (4) check the pressure of the running motor.
When to remove hydraulic regulator from Kobelco excavator?
Hydraulic pump regulator plug off belongs to the emergency mode, it is recommended to remove P1, P2 pump regulator hand toggle plug regulator, to see whether the card issuers need to plug, service personnel, by the way can remove after cleaning pump proportional valve diesel engine.
Where can I buy a Kobelco sk350lc-10 specs?
SK350LC-10 Specs – KOBELCO Conventional Excavator Note: This document may contain attachments and optional equipment that are not available in your area. It may also contain photographs of machines with speciļ¬cations that differ from those sold in your area. Please contact your nearest KOBELCO dealer for items you require.
What’s the repair manual for a Kobelco excavator?
This Factory Service Repair Manual offers all the service and repair information about Kobelco Mark-8 Series SK350 Excavator. The information on this Kobelco manual PDF covers everything you need to know when you want to repair or service Kobelco Mark-8 Series SK350 Excavator.
What does the CPU light on a Kobelco mean?
KOBELCO Resigned PARTS & SERVICE MGR. AMOUNG OTHER HATS @ KOBELCO D i do believe you are right on the money with that one. the cpu light is an indication of a problem that has occurred in the cpu or with the main power feeds or grounds.
When do I need to replace my Kobelco arm 2 spool?
AMOUNG OTHER HATS @ KOBELCO D you will require the following new replacement parts. the ARM 2 spool supercedes, including a new lower spool cap and detent plug. also the 2 unloading valves supercede part numbers and should also be replaced.
