How to replace distributor spar and curve in Corvair?
How to replace distributor spar and curve in Corvair?
Fig. 8-2-Distributor Spar~ Curve MAINTENANCE AND ADJUSTMENTS Contact Point Replacement Refer to Figures 8-3 through 8-5 1. Release distributor cap hold-down screws, remove cap and place it out of work area. 2. Remove rotor.
What kind of electrical systems does Corvair use?
CORVAIA SHOP MANUAL SUPPLlEfoIlENT ELECTRICAL SYSTEMS 8-2 Fig. 8-2-Distributor Spar~ Curve MAINTENANCE AND ADJUSTMENTS Contact Point Replacement Refer to Figures 8-3 through 8-5 1.
How to remove a Corvair vacuum control unit?
1. Remove rotor. 2. Remove vacuum control assembly retaining screws, remove unit from distributor housing. 3. Disconnect primary and condenser leads from contact point quick disconnect terminal, remove contact point set attaching screw, condenser at taching screw, remove point set and condenser from breaker plate.
How to disconnect primary condenser from Corvair breaker plate?
Disconnect primary and condenser leads from contact point quick disconnect terminal, remove contact point set attaching screw, condenser at taching screw, remove point set and condenser from breaker plate. CORVAIR S HOP MANUAL SUP’PLJ:MI[NT
Fig. 8-2-Distributor Spar~ Curve MAINTENANCE AND ADJUSTMENTS Contact Point Replacement Refer to Figures 8-3 through 8-5 1. Release distributor cap hold-down screws, remove cap and place it out of work area. 2. Remove rotor.
How to open 8 s selting point Corvair?
8-S-Selting Point Opening CORVAIR SHOP MANUAL SUPPLEMI:NT 5. Clean breaker plate of oil smudge and dirt. 6. Place new contact point assembly in position on breaker plate, install attaching screw. CAUr/ON: Carefully wipe proledive “/m from point se’ prior to ins’allation.
CORVAIA SHOP MANUAL SUPPLlEfoIlENT ELECTRICAL SYSTEMS 8-2 Fig. 8-2-Distributor Spar~ Curve MAINTENANCE AND ADJUSTMENTS Contact Point Replacement Refer to Figures 8-3 through 8-5 1.
What causes weak spark on 1966 Chevy Corvair?
Check with a multimeter that with the key in the ‘ON’ position the coil is receiving 12-14 volts. Foul or improperly gaped spark plugs can cause a weak spark. remove each spark plug and inspect its condition. if fouled or damaged, replace them.
What should I do if my Corvair coil is not receiving power?
If your coil is not receiving power, no ignition will occur. Check with a multimeter that with the key in the ‘ON’ position the coil is receiving 12-14 volts.
