How to remove the factory radio in a 2007 Dodge Ram 1500?
How to remove the factory radio in a 2007 Dodge Ram 1500?
How to Remove the Factory Radio in a 2007 Dodge Ram 1500 Locate the two Phillips-head screws in the dash recess below the a/c controls. The heads on these screws face the ground. Remove these screws using the Phillips-head screwdriver. Pull the dash bezel around the radio and the a/c controls away from the dashboard using your hands.
How do you change the stereo in a Dodge Ram?
Pry up the insert in the top of the shift knob, then remove the exposed nut. Pry around the perimeter of the shift boot and lift it over the shifter. That will expose two 8mm screws, which you’ll need to remove. Other trucks have a pen tray here, instead of a shifter. You’ll need to pry the tray up, then remove the two exposed 8mm screws.
What kind of stereo does a Dodge Ram 3500 have?
The cabs and the disassembly instructions are the same whether you have a 1500, 2500, or 3500, so we’ve divided the line by cab configuration. The Ram’s stock receiver can be replaced by a variety of aftermarket models (Crutchfield Research Photo) The Ram Quad Cab’s base radio was a thoroughly average AM/FM/CD receiver with 4 speakers.
How do you remove a stereo from a car?
Pull the bezel away from the dashboard, then shift the transmission back into park and turn the key off. Hold down the two levers on the sides of the factory stereo with your hands. Pull the stereo out and remove the wiring at the backside with your hands.
Pry up the insert in the top of the shift knob, then remove the exposed nut. Pry around the perimeter of the shift boot and lift it over the shifter. That will expose two 8mm screws, which you’ll need to remove. Other trucks have a pen tray here, instead of a shifter. You’ll need to pry the tray up, then remove the two exposed 8mm screws.
The cabs and the disassembly instructions are the same whether you have a 1500, 2500, or 3500, so we’ve divided the line by cab configuration. The Ram’s stock receiver can be replaced by a variety of aftermarket models (Crutchfield Research Photo) The Ram Quad Cab’s base radio was a thoroughly average AM/FM/CD receiver with 4 speakers.
Where are the speakers on a Dodge Ram?
The Ram’s 4-speaker system has speakers in the front doors and, depending on the cab, somewhere behind the rear seat.
Can a Dodge Ram be replaced by an aftermarket receiver?
The cabs and the disassembly instructions are the same whether you have a 1500, 2500, or 3500, so we’ve divided the line by cab configuration. The Ram’s stock receiver can be replaced by a variety of aftermarket models (Crutchfield Research Photo)
Do you need to remove the dash on a Dodge Ram?
When adding a new stereo or navigation system to your Dodge Ram, it will require removing a part of the front dash to access the mounting bracket. The part of the front dash that contains the factory-installed stereo is called the dash bezel.
How do you remove the radio from the dash?
Pull the dash bezel around the radio and the a/c controls away from the dashboard using your hands. This will release the clips that hold the bezel to the dash. Unbolt the radio from the dashboard using the 1/4-inch ratchet, extension and a socket.
How to replace stereo head unit in Dodge Ram?
Snap on the center console cover over the new stereo head unit. Reattach the center console trim cover. Fasten the screw behind the small hook. Reattach the lower dash trim panel. Then, snap on the stereo’s face plate and test the unit. Figure 13. Aftermarket stereo head unit installed.
How do you change the radio on a Dodge Ram?
Pull the panel out, disconnect the wiring harnesses, and remove. Be sure to use a pry tool, or at the very least, put a thick sheet of paper behind the panel to protect it. The factory radio is held in place by four Phillips screws. Remove them, disconnect the harness, and remove the radio.
What kind of stereo system does Dodge Ram have?
The upgraded version featured an Infinity system with an AM/FM/MP3 6-CD changer and seven speakers. A navigation receiver could also be paired with the 7-speaker stereo. These systems range from okay-ish to not-bad, but in a brash, brawny truck like this, that’s just not going to cut it.
Where is the dash trim on a Dodge Ram?
Use a trim removal tool to pry out the driver’s side lower dash trim panel located on the right side of the steering column. Figure 1. Remove the lower dash trim piece. On the right side of the center console there is a screw covered by a small hook. Use a Phillips screwdriver to remove the screw.
