How much horsepower does a DT466E have?
How much horsepower does a DT466E have?
300 hp
The most modern version of this iconic engine is the MaxxForce DT466E. Making 300 hp at 2,200 rpm and 860 lb-ft of torque at 1,300 rpm, the engines have long been a favorite of medium-duty fleet operators and short-haul truckers.
How many cylinders is a DT466E?
Layout. The DT466E engine is an inline, six-cylinder powerhouse with a displacement of 466 cubic inches. Its diesel-powered propulsion offers a fuel-efficient alternative to gasoline engines of this size and power.
How much horsepower does a 1999 International dt466e have?
Standard torque models of the 1999 DT466E offer power ranges of between 195 and 230 horsepower, with torque ratings advertised at 520 to 620 foot-pounds of torque. International also provided high-end torque models, producing 215 to 250 horsepower and 620 to 800 foot-pounds of torque. The aluminum pistons give the DT466E engine its life and power.
Why is my International 4700 engine not starting?
I am dealing with an international 4700 w/ the dt466e engine option and am unfamiliar with the fuel and engine control system. The drain plug on the high pressure oil pump was stripped and was run dry, truck was then shut off, and would not restart several hours later after being refilled.
Why does my dt466e no start-fuel problem?
Got that all fixed. Realized that my primer pump would leak when I would pump it, replaced the entire assembly. Filled both filters, truck fired on the first try. Now today go to run a call, cranks and cranks wont start. Gave a shot of ether, fires but wont run on diesel.
Where is the fuel pump on a DT-466?
JaymZH2 wrote: fuel pump would be my guess. not sure on the older ones, but the newer DT’s it is on the drivers side mid block towards the front. a couple bolts a 2 lines and your done. I have a 2000 4700 DT-466, would what you call the fuel pump be the same thing they call the “high pressure pump” in the book that the lines from the filter go to??
What’s the fuel pressure on an international dt466e?
Pressure while cranking is around 890 psi. With the pump dead headed to a gauge it is 4000 psi. I have changed the icp sensor and the ipr valve. fuel pressure is around 60 psi while cranking with the needle on the gauge bouncing. Also have installed new fuel pressure regulator. I would have to by a computer to swap.
Why does my 1999 IH dt466e keep dying?
I have a 1999 IH DT466E that will not stay running. It will start right up and then run from anywhere from 30 secs. to several minutes. It then dies, but will start back up and do the same thing. I have replaced the fuel filter on the drivers side, and the high pressure oil pump is also new last fall.
Where is the HPOP on a 1999 dt466e?
On the left side of the engine mounted on the back side of the front cover is the high pressure oil pump. Its also right above the air compressor ( if equipped) or ps pump. On the hpop there is a valve near the bottom of it.
What is the ICP on an international dt466e?
The icp is between 800 and 900 psi while cranking, fuel pressure is I have an international dt466e that will not start. The icp… HeavyEquipmentTech : Hi my name is***** will try to help.
