Where is the brake control box on a 1999 Chevy?
Where is the brake control box on a 1999 Chevy?
This junction box (shown below) is located on the driver’s side below the dash, left of the brake pedal. If the factory brake control adapter cannot be found, we offer a replacement (for model years 1999-2002 use 3025-S, for years 2003-2006, including 2007 Classic models use 3015-S).
Where do you run the brake wire on a truck?
Usually the wire is run either inside or above the frame on the driver’s side of the truck. Once run, connect the white (brake) and black (hot) to the blue (brake) and black (hot), respectively, on the back of the 6- or 7-way adapter.
How to install a brake controller on a Chevy?
If a hot lead is also needed connect the black wire (shown in red for clarity) to the other auxiliary positive post. A 40 amp fuse needs to be placed in the last spot, closest to the post, to power the hot lead (see picture).
This junction box (shown below) is located on the driver’s side below the dash, left of the brake pedal. If the factory brake control adapter cannot be found, we offer a replacement (for model years 1999-2002 use 3025-S, for years 2003-2006, including 2007 Classic models use 3015-S).
Usually the wire is run either inside or above the frame on the driver’s side of the truck. Once run, connect the white (brake) and black (hot) to the blue (brake) and black (hot), respectively, on the back of the 6- or 7-way adapter.
If a hot lead is also needed connect the black wire (shown in red for clarity) to the other auxiliary positive post. A 40 amp fuse needs to be placed in the last spot, closest to the post, to power the hot lead (see picture).
Is there a way to bleed GM ABS brakes?
How to Bleed GM ABS Brakes. Bleeding the brake system after changing the brakes can be hard on some anti-lock braking systems. The good news is that on some GM vehicles, a scan tool isn’t needed to bleed ABS brakes. A scan tool is only needed with a DBC-7 anti-lock braking system, and then only if air entered the ABS modulator during brake service.
How to replace the parking brake cable on a Chevy?
Disconnect the front cable from the intermediate cable and then disconnect the intermediate cable from the main bracket. Press the tangs on the cable casing with needle-nose pliers and then pass the cable and casing through the next bracket.
How do you Bleed the brakes on a Chevy Silverado?
Close the screw, then bleed both front brakes starting with the right one first. After checking for a firm pedal, drive the vehicle above three miles per hour. The controller will automatically reset the system by commanding the rear motor to run to the home position.
What kind of brakes does a Chevy Silverado have?
The modulator assembly has fluid chambers for all four brakes, two isolation solenoid valves, four check balls, a motor pack containing three bidirectional direct current motors with electromagnetic brakes (EMBs) and/or expansion spring brakes (ESBs), three ball screw assemblies, four pistons, a gear drive set and gear cover.
How to install a brake controller on Chevrolet / GMC 1999?
Hardwire the open wires of the brake control adapter to the wires on the brake controller. Plug the other end of the adapter into the electrical junction box (see above). Mount the brake controller in a place that is easily accessible. A: Remove the bracket in the corner closest to the driver. B: Remove the top cover of the “Accessory Fuse Block”.
Where is the brake control adapter plug located?
After mounting the brake controller in a place that is easily accessible, your installation is complete. The brake control adapter plug is located in the electrical junction box on the driver’s side, left of the brake pedal.
