How does a power car antenna work?
How does a power car antenna work?
A power antenna motor, which is basically a cylindrical rotor that spins, is the part that becomes energized when the car ignition switch is turned on. This motor propels the antenna up out of its housing upon activation, and it also collapses the antenna when the ignition switch is turned off.
How does Auto transmit power work on AP radios?
Auto transmit power leverages RF data gathered by an AP to decide which radio transmit power levels would be best for client roaming and performance. More information on the Auto Power algorithm can be found in our Auto TX article. By default, all AP radios are configured to use Auto Power .
How can I change the transmit power of my Radio?
From the Wireless > Configure > Radio Settings page, select either 2.4 or 5 from the Band dropdown menu to modify the correct radio. Select the number/link in the Target power (dBm) column of a specific AP. Select Manual and choose the desired transmit power for the specified radio.
How to build a ferrite rod antenna coil?
Designing an AM radio ferrite rod antenna coil (also known as tank circuit) for a crystal radio project or any radio project is something GCSE students and hobbyists love rushing into with guesswork. This article takes the guesswork out of building a coil, and shows how you could calculate the values to design and build an accurate tank circuit.
Why do I need an antenna on my AP?
Antenna Configuration. For external antenna options, the dashboard needs to have an antenna configured in order to enforce regulatory restrictions like EIRP. On the Radio Settings page, click on the AP to view the RF configuration, then select the antenna physically installed on the AP.
Where are the satellite antennas on a truck?
Satellite Radio & Cellular Antenna Relocation Guidelines There are connections for both the SDARS and cellular antennas on the back of the radio depending upon which radio option the truck is equipped with.
How do you put an antenna on a Harley Davidson?
Peel the liner from one side of the tape, and apply the tape squarely to the bottom surface of the antenna. 7. Peel the liner from the exposed side of the adhesive tape on the antenna base. 8. Position the antenna over the diagram on the bracket without touching the adhesive to the bracket.
What kind of antenna does a ram truck use?
The shark fi n is used for vehicles equipped with satellite radio & navigation (SDARS) AND Cellular Mobile Media. (U Connect Access Advantage) The puck is installed on vehicles with SDARS only. If there is a shark fin, there will be two antenna wires. One is for SDARS (thin wire) and the other (thick wire) is for cellular.
Where is the jumper wire on a car radio?
There will be a relatively short length of antenna wire (jumper) running from the radio to one of two locations depending upon the location of the antenna on the vehicle roof. Two Locations er The connector is a single blue connector.
