How do you reset the service light on a 2011 Ford Mondeo?
How do you reset the service light on a 2011 Ford Mondeo?
Reset oil service light Ford Mondeo
- Get in the vehicle ensure all doors are closed.
- Then press both the accelerator and the brake pedal and hold them down.
- Then switch the ignition ON, do not start the engine.
- .
- Now wait 15 seconds.
- .
- Take feet of pedals.
- Press ok to close.
What are the common problems with Ford Mondeo engines?
Solution: A common problem with this year TDCi engine is a bad connection for the fuel pressure sensor. To rectify the problem, a gold electrical connector should be used instead of the tin connector. Problem: Engine does not run properly or fails to start.
Where does the clutch come from on a Mondeo?
IF – and I emphasise IF – It’s like the Vectra C, then the clutch hydraulics are fed from the brake resovoir. Give the brake system a full bleed.
Why is the fuel flap on my Mondeo not opening?
The solution is to fit a clip to the clutch spring stop to prevent spring elongation. Problem: Fuel flap does not open. Solution: The probable cause is insufficient spring pressure from a lack of material on the flap. A revised filler flap should be fitted. The revised flap has an extra 1mm of material to ensure spring contact.
Where is the slave cylinder located on a Mondeo?
Mondeo will have slave cylinder located within the gearbox bell housing-known as concentric slave cylinder-all now part of release bearing assembly. Try looking to see if any fluid is dripping off the bottom of gearbox where it mates to the engine,you may need to drop under engine tray.
Solution: A common problem with this year TDCi engine is a bad connection for the fuel pressure sensor. To rectify the problem, a gold electrical connector should be used instead of the tin connector. Problem: Engine does not run properly or fails to start.
The solution is to fit a clip to the clutch spring stop to prevent spring elongation. Problem: Fuel flap does not open. Solution: The probable cause is insufficient spring pressure from a lack of material on the flap. A revised filler flap should be fitted. The revised flap has an extra 1mm of material to ensure spring contact.
What causes a knocking noise in a Ford Mondeo?
Solution: A common problem is a hydraulic ‘water hammer’ effect in the power steering system, whcih can cause a knocking noise. The solution is to fit a new revised power steering return line that is designed to absorb pressure peaks of the hydraulic system. A revised return line has been fitted since 10/1999 (diesel) and 12/1999 (petrol).
What’s the problem with my Ford Mondeo brake pads?
Problem: Repeated premature rear brake pad wear and / or rear brake squeal. Solution: The probable cause is sticking pads in the back plate asembly. The solution is to thoroughly clean the support area for the pads and fit new revised pads. Grease the pad supports with molycote silicone grease.
