How do you install a shift kit on a Ford?
How do you install a shift kit on a Ford?
Once you have the right combination of 2-3 shift accumulator springs and washer/spacer in the bore, install the cover and verify the proper seating of the C-clip. Discard the factory’s thimble-shaped filter and install one of two provided tapered orifices included in the kit.
What kind of shift kit does a Ford C4 use?
Their first effort was known as the B&M Hydro Stick 4-speed automatic. B&M’s vast experience with automatic transmissions includes the Ford C4 Transpak kit (PN 50227), which is for 1964–1966 C4 Dual- Range Green Dot transmissions, a rare treat for these early first-generation C4s with their unique valve bodies.
Where are the check balls in a Ford shift kit?
Take note of where all the check balls and other small parts are located (arrows). Remove this tiny filter and either replace or reuse it. If reused, it must be cleaned.
What to do with Ford AODE 4R70W shift kit?
This kit also improves clutch fluid loss that damages the overdrive band and forward clutch. While your AODE/4R70W is apart, TransGo recommends using its special forward clutch sealing rings with the chamfer side away from the fluid feed hole.
Once you have the right combination of 2-3 shift accumulator springs and washer/spacer in the bore, install the cover and verify the proper seating of the C-clip. Discard the factory’s thimble-shaped filter and install one of two provided tapered orifices included in the kit.
Where can I buy 1994 Ford body parts?
RockAuto ships auto parts and body parts from over 300 manufacturers to customers’ doors worldwide, all at warehouse prices. Easy to use parts catalog. 1994 FORD Parts | RockAuto
Take note of where all the check balls and other small parts are located (arrows). Remove this tiny filter and either replace or reuse it. If reused, it must be cleaned.
How big do you drill holes in Ford shift kit?
Enlarge the holes per the marking (here to .93 inch) and TransGo instructions with drill bits provided. This is why you must mark the separator plate and circle the holes beforehand. You will learn from the instructions where to drill and what size to drill with the drill bits included in the kit.
