How do I reset my Control4 SR 260 remote?

How do I reset my Control4 SR 260 remote?

1. take on battery half way out.
2. press “red 4” button and “0” same time.
3. keep pressing and push battery in.
4. keep pushing buttons and wait till remotes buttons start to blink (5- 10 sec.)
5. wait till the end of the process (or leave it alone for 10 min)
6. re identify. Link to comment. Share on other sites. More sharing options…

Why is my Control4 remote not working?

If your remote isn’t working or your touch screen is drawing a blank, make sure your batteries are charged. A Control4 Remote Recharging Station works wonders for Control4 remotes by offering long-lasting reliability—and they’re more environmentally friendly than disposable batteries, too.

How do I sync my Control4 remote to my Apple TV?

Point your remote three inches away from your Apple TV. Then press and hold your remote’s Menu and Volume Up buttons for five seconds. If asked, place your remote on top of Apple TV to complete pairing.

How do I brighten my control 4 remote?

To change the remote’s preferences: 1 Press LIST, then select Settings, then Config. To change the List interface’s brightness or the keypad brightness, select Display Brightness or Keypad Brightness, press the arrow buttons to adjust, then press SELECT.

How do I make my control 4 remote brighter?

To display remote brightness Press LIST, then select Info > Config > Display Brightness. To display remote keypad brightness Press LIST, then select Info > Config > Keypad Brightness. To turn on keypad backlight Press LIST, then select Info > Config > Light Sensor. Select On or Off.

How do I brighten my Control4 remote?

Does Apple TV work with Control4?

This Apple TV Driver for Control4 allows for the integration and control of an Apple TV 4th generation or an Apple TV 4K (5th and 6th generation) running either tvOS 13 or 14 from within Control4.

Does Control4 work with Apple?

Note: The Control4 app works with both Android (v5. 1 and newer) and iOS (v12 and newer) devices.

How do I connect my Control4 remote?

In the Connections view, click the Network tab. Select the System Remote Control SR-250 in the center pane. Click Identify (or right-click and choose Identify). When prompted to do so, press the red 4 button four (4) times to identify the device to the Control4 system (Figure 2).