Do you need to replace the speedometer face?
Do you need to replace the speedometer face?
From custom gauge faces, such as our Stainless Edition or our custom colored Daytona Edition faces, to direct replacement or conversion gauge faces, US Speedo© has what you need for your speedometer. US Speedo© also carries a full line of replacement components at a much more reasonable price than any dealer.
Where can I get a US Speedo speedometer?
Please enter your make, model, year and trim to find the right fit for your vehicle! Located in Flint Michigan, US Speedo is the leading manufacturer of better than OEM quality speedometer restyling products. Since 1999, US Speedo has strived to offer cutting edge technology, ahead of the aftermarket curve.
Are there custom gauge faces for US Speedo?
US Speedo has produced thousands of custom gauge faces with lines for upfitters such as Saleen, Roush, SCA, and others. 2018 Jeep JL. Get yours today!
How to install a speedometer Hall effect sender?
Set all DIP-switches to the “ON” (#1) position. Install and wire the speedometer as shown earlier. 2. Drive a known course with a distance of up to 10 miles. Be sure the speedometer pointer DOES NOT exceed the maximum speed of the speedometer while traveling the course. Reducing your speed may be necessary to prevent damage to the speedometer. 3.
What should I do if my speedometer reading is erratic?
If an erratic reading occurs, go back and retrace thecalibration process to be sure that the sensor is providing enough pulses per mile to give an accurate sensor signal to the speecometer as described in Section 1. The speedometer comes with a 10 position DIP-switch on the back of the unit. All switches are preset to “ON” (ON=1; OFF=0).
Set all DIP-switches to the “ON” (#1) position. Install and wire the speedometer as shown earlier. 2. Drive a known course with a distance of up to 10 miles. Be sure the speedometer pointer DOES NOT exceed the maximum speed of the speedometer while traveling the course. Reducing your speed may be necessary to prevent damage to the speedometer. 3.
Where are the DIP switches on a speedometer?
The speedometer comes with a 10 position DIP-switch on the back of the unit. All switches are preset to “ON” (ON=1; OFF=0). If you already know how many pulses your vehicle or sender will generate, please see the Calibration Table. Using the binary code (ones and zeros), set the DIP-switches and mount the speedometer in the dash panel.
Can a speedometer be connected to a battery?
Do not program speedometer with battery connected or the key switch inthe “ON” posi- tion. If an erratic reading occurs, go back and retrace thecalibration process to be sure that the sensor is providing enough pulses per mile to give an accurate sensor signal to the speecometer as described in Section 1.
