Most popular

Why does my thermostat not turn on when the air conditioner is on?

Why does my thermostat not turn on when the air conditioner is on?

If it is not, the thermostat cannot signal the air conditioner to cycle on. Look for and address simple reasons why the thermostat isn’t getting power, such as dead batteries or a tripped breaker or blown fuse in your main electrical service panel.

What causes an air conditioner compressor to disengage?

The A/C system is designed to disenage the A/C if the pressure in the lines is to low. This happenes to protect the system. Compressor could be disengaged becasue the system does not have enough refrigerant pressure to trip the low pressure cutoff switch that cycles the compressor. Be careful to not overcharge the system either.

What to do if your thermostat is stuck?

If this is the case, it’s easily corrected by placing a carpenter’s level above or below the thermostat and adjusting it so it’s sitting level. A stuck heat anticipator is another possible culprit if the thermostat is a mechanical model.

What causes a refrigerant compressor to loose temperature?

Expansion of refrigant causes the temperature of the refrigerant to drop. This is the oposite process that the compressor performs. Put pressure into a fluid you will increase it’s temperature. Removeing pressure from fluid causes it to loose temperature.

Why is my air conditioner clutch not working?

If your Air Conditioning compressor isn’t working (the clutch won’t engage) then watch this video. The A/C switch on the dash switches the compressor on, with one exception. If the PCM (powertrain control module) senses low pressure in the low pressure fluid line, it will stop the compressor clutch from engaging to prevent any damage.

What happens when the clutch on an AC compressor breaks?

When the compressor clutch breaks, the bearing inside the compressor can become damaged as well. While it’s not common to see fluid leaking through the front seal because of a failed AC compressor clutch, it’s not unheard of. Look at the compressor to see if there are any signs liquid is leaking out through the front seal.

What to do if your a / C compressor won’t engage?

HOWEVER, if you cannot turn the compressor on, you cannot recharge your AC levels (grrrr). So you need to use a paper clip to bypass the relay switch and force the clutch to engage. You can then recharge the freon and re install the relay switch and it will sense more pressure and the clutch will engage by itself. Loading…

What’s the best way to troubleshoot an AC thermostat?

Dirt in the AC thermostat is one of the most common causes of problems, so a good troubleshooting method is to just clean the thermostat. First, ensure the power is turned off, and then remove the cover of your thermostat.

Author Image
Ruth Doyle