Most popular

Why does my front tire move right or left when I brake?

Why does my front tire move right or left when I brake?

A tie rod end holds the spindle which supports the tire when steering your car. This part can wear as all suspension parts do allowing the front tire to move right or left when the brake are used. To check for this problem grasp the front wheels one at a time and move them back and forth while watching the tie rod. There should be no visible play.

What causes tires to clunk when applying brakes?

It could be incorrectly torqued wheels, loose disc brake calipers, brake pad shims, suspension pieces loading/unloading from the weight shift. If they just did the tires, take it back and tell them to take a look (for free). Try slowing the car down with the engine. If it’s manual, just downshift.

Why does my car pull when I put the brakes on?

The brake system depends on even pressure to be applied to the front right and left caliper and the rear brake shoes or pads. If this pressure is offset due to a malfunction the car will pull when the brakes are applied.

What causes rear drum brakes to engage too soon?

If the parking brake system is not de-adjusted properly before the brake shoes are adjusted it will cause the rear brakes to engage too soon. This is especially true of vehicles equipped with duo-servo rear drum brakes (see Figure 61.1).

What causes rear wheel to lock up when braking?

Problem: One or both rear wheels lockup during braking or the rear end of the car squats when braking. Cause: Rear Wheel lockup or squatting has many causes. Here is the list of possible causes: Service and parking brake adjustment. Rear brake hardware. Shoe lands or bosses. GM clip in wheel cylinders. Brake drum condition.

If the parking brake system is not de-adjusted properly before the brake shoes are adjusted it will cause the rear brakes to engage too soon. This is especially true of vehicles equipped with duo-servo rear drum brakes (see Figure 61.1).

Why are the hold down Springs on my rear brake so weak?

Hold down springs are designed to keep the brake shoe firmly against the backing plate. If the hold down springs are weak then the shoe could cock causing a binding condition. The replacement of rear shoe hardware should be suggested each time the rear brake shoes are replaced to prevent this from happening.

Why are my brakes not going to retract?

As you use your brakes you are allowed to pressure your brakes to stop but they will not retract (open) because you either have a clog in one of the brake lines or you need a new Master Cylinder, Or you may need a New Power Brake Booster.

Author Image
Ruth Doyle