Where can I get Oil for a trans axle?
Where can I get Oil for a trans axle?
Contact your local fuel and oil wholesaler. They will have a cross reference from the case fluid to something they carry. That’s what I do on a regular basis. On the Case IH forum there was a poster who went by the handle “Brokengun”.
What can I use in trans axle of a 580K,?
When changing the oil you will need to add 3 bottles of 402982A2 axle additive – for the wet brakes. There are aftermarket oils that will run in the transaxle – But there is no EXCACT equivalent for HY Trans Ultra (MS 1209) – it is specially formulated, under license, for CNH.
What kind of oil does a Maxxum transaxle use?
If your machine has a dipstick back by the swing tower DO NOT use 90 wt. gear oil, It’s obvious the Case dealer you spoke to has idiots for personell. HyTran Ultra is the only oil that is recommended for that transaxle. For info’s sake only, that transaxle is just the rear section of the Maxxum Ag tractor line. I’ll get the HyTrans oil………
What kind of oil does a Phase 3 transaxle use?
The phase 3 transaxle will need 50lts on a service & 60lt on an overhaul. When changing the oil you will need to add 3 bottles of 402982A2 axle additive – for the wet brakes.
Contact your local fuel and oil wholesaler. They will have a cross reference from the case fluid to something they carry. That’s what I do on a regular basis. On the Case IH forum there was a poster who went by the handle “Brokengun”.
How to replace oil seal on transfer case?
1. If equipped remove the plastic undercarriage cover beneath the driver’s side door using a Ratchet & a 12mm socket. This image has been resized. Click this bar to view the full image. The original image is sized %1%2. 2. Remove the four bolts securing the Transfer Case Skid Plate using a Ratchet & a 12mm Socket.
What to use to seal rear axle of lawn tractor?
Use RTV sealant to seal the the case halves back as there is no gasket. I believe this transmission will take 10ounces of 80W90 gear oil, but measure from the top edge of the oil port hole and measure down to the oil; it should be between 1.5-1.75inches from edge to oil. @Sean: Remove the wheel first and see if you can see the oil seal face though.
Can a transfer case output shaft be replaced?
This is a write-up on how to replace the Output Shaft Seals on your Transfer Case. Gear oil leakage from these seals is a common problem on 3rd gen 4Runners, but there is not much information on the replacement procedure available on the web for DIY’ers.
