Where can I buy a temperature sensor plug?
Where can I buy a temperature sensor plug?
4B0-973-712 is the smaller plug used for the Temperature sensor, AIT sensor, Throttle Body and like connections. That part will run about $12 at the dealership. These plugs can also be ordered online from ECS Tuning for about $18 and $9.
How much does a 4b0-973-712 temperature sensor cost?
4B0-973-712 is the smaller plug used for the Temperature sensor, AIT sensor, Throttle Body and like connections. That part will run about $12 at the dealership. These plugs can also be ordered online from ECS Tuning for about $18 and $9. Let’s MacGyver This B!! Yeah, welcome back to the ’80s.
What to do when your plug harness breaks?
Push the pins back into your new plug with your fingers, or with pliers if that helps. Make sure you write down which color wires come out of each hole. The plug harness will be labeled with 1, 2, 3, and 4. These are some drawings that should help with understanding the pin connector and keeping the wires in proper order.
How is the aftertreatment temperature sensor used in an engine?
The aftertreatment temperature sensors are used by the engine control module (ECM) to monitor the engine exhaust temperatures in the aftertreatment system. The aftertreatment temperature sensors are thermistors and change resistance based on the temperature being measured. The ECM provides a 5 volt reference voltage to the sensor.
Where does the ambient air temperature sensor connect?
The ambient air temperature sensor connector attaches the sensor to the wiring needed to connect to the control unit for the heating, ventilation, and air conditioning (HVAC) system to keep from putting additional stress on the system in especially hot or cold climates. The connector also attaches the sensor to the ECU to display…
How to connect the aftertreatment Diesel Oxidation Catalyst inlet temperature sensor?
Disconnect the aftertreatment diesel oxidation catalyst inlet temperature sensor from the wiring harness. Connect two service test leads, Part Number (NNN) NNN-NNNN of the electrical test kit, Part Number (NNN) NNN-NNNN to the aftertreatment diesel oxidation catalyst inlet temperature sensor harness connector.
How to test aftertreatment diesel particulate filter inlet temperature sensor?
Connect two service test leads, Part Number (NNN) NNN-NNNN of the electrical test kit, Part Number (NNN) NNN-NNNN to the aftertreatment diesel particulate filter inlet temperature sensor harness connector. Use a digital multimeter to record the resistance value of the aftertreatment diesel particulate filter inlet temperature sensor.
