What is the best gear ratio for towing and fuel economy?
What is the best gear ratio for towing and fuel economy?
FACT: A 3.73 axle ratio is ideal for towing heavy loads on flat terrain and will produce increased fuel economy during steady-state, long-distance highway driving.
Can a Harley Davidson run at low speeds?
However, since I bought it the engine is not running well at low speeds. It basically runs fine under mild/strong acceleration or at full highway speed and seems to idle normally when the bike is started.
How long does a diesel engine run at low power?
To upload images, use the Upload a FIle button found towards the bottom right of the post response box or a new thread. Diesel runs great for 1/2 hour then very low power. Discussion in ‘ Yanmar ‘ started by Cal, May 3, 2010 . This has me baffled.
Why does my Maxxforce Engine have a low power tip?
The main cause of this is a plugged up engine crankcase breather. A service kit is available for the MaxxForce DT diesel engines that allows mechanics to disassemble the low pressure and high pressure turbocharger on the compressor side (intake) and remove the soot buildup.
How long does a ym240 diesel engine run?
I started my YM240 (24 hp diesel) this spring and it runs absolutely fine for about 1/2 hour – plenty of power under load, no smoke, no blowby, everything seems normal. Then, after about 1/2 hour it starts losing power and in a period of about 3-4 minutes it loses so much power that it can’t climb a small grade unless I drop it into 1st gear.
However, since I bought it the engine is not running well at low speeds. It basically runs fine under mild/strong acceleration or at full highway speed and seems to idle normally when the bike is started.
What’s the weird cutting out issue at higher RPM?
Discussion in ‘ Engine Topic ‘ started by gramps, Mar 18, 2012 . Alright so I’m tryin to figure out what the heck is going on with my motor. Tromp on it and she’s a tire shredding beast, untill it starts getting to 3500+ rpm, not so bad in 1st gear but 2nd is worse and 3rd is real bad.
What happens when engine idle speed is above programmed range?
When the engine idle speed is either above or below the programmed range, the ECU prompts the ISC to either increase or decrease bypass airflow. Naturally, as the IAC prompts the throttle plate to open, engine speed increases. The IAC features a plunger mechanism that may be stuck/sticking.
Which is better 305 or 305 Dist motor?
The one in the old motor is super stiff to move, they stay wherever they get pushed to. The 305 dist, moves the best, the swing out easily, and return to closed pos easily on their own. I noticed that they all have numbers stamped into them.
