What are the diagnostics for a Ford Bronco Corral?
What are the diagnostics for a Ford Bronco Corral?
112 (O,M) Intake Air Temperature (IAT) sensor is/was low or grounded – IAT 129 (R) No MAP or Mass Air Flow sensor change during “goose” test – MAP MAF 136 (R) Oxygen sensor not switching/system lean Left or Front HO2S – Fuel control 137 (R) Oxygen sensor not switching/system rich Left or Front HO2S – Fuel control
What is the out of range sensor on a Ford Bronco?
24 – Intake Air Temperature (IAT) or Vane Air Temperature (VAT) sensor out of range – IAT VAT Transmission Oil Temperature (TOT) sensor out of range – Transmissions 2.3L w/Electronic Ignition – Cyl ID, IDM low or right coil pack failure – Ignition Systems
What is oxygen sensor not switching in Bronco Corral?
172 (R,M) Oxygen sensor not switching – system is or was lean – Single, Right or Rear HO2S – Fuel control 173 (R,M) Oxygen sensor not switching – system is or was rich – Single, Right or Rear HO2S – Fuel control 174 (M) Oxygen sensor was slow in switching Single, Right or Rear HO2S – Fuel control
Where is the fuel injection code on a Bronco?
40 – Series Fuel/Air Injection Codes On Vehicles With Dual Oxygen Sensors Refer To The Right Or Rear Sensor Except: 1984-1988 3.8L Engines: Left Sensor (M) System was lean for 15 seconds or more (no HO2S switching) – Fuel control (M) System was rich for 15 seconds or more (no HO2S switching) – Fuel control
24 – Intake Air Temperature (IAT) or Vane Air Temperature (VAT) sensor out of range – IAT VAT Transmission Oil Temperature (TOT) sensor out of range – Transmissions 2.3L w/Electronic Ignition – Cyl ID, IDM low or right coil pack failure – Ignition Systems
112 (O,M) Intake Air Temperature (IAT) sensor is/was low or grounded – IAT 129 (R) No MAP or Mass Air Flow sensor change during “goose” test – MAP MAF 136 (R) Oxygen sensor not switching/system lean Left or Front HO2S – Fuel control 137 (R) Oxygen sensor not switching/system rich Left or Front HO2S – Fuel control
When to test the Ford EGR valve solenoid?
The following are the most common symptoms that a Ford (or Mercury or Lincoln) car or truck will usually experience when there’s a fault in the EGR System: Car or truck runs fine, but the check engine light (CEL) is on with an EGR Valve Fault Code: P0401 EGR System Flow Insufficient. P01406 EGR Valve Pintle Position.
172 (R,M) Oxygen sensor not switching – system is or was lean – Single, Right or Rear HO2S – Fuel control 173 (R,M) Oxygen sensor not switching – system is or was rich – Single, Right or Rear HO2S – Fuel control 174 (M) Oxygen sensor was slow in switching Single, Right or Rear HO2S – Fuel control
