How to power the rear outlet without turning the key?
How to power the rear outlet without turning the key?
1. Remove the key from ignition and make sure you don’t have wet hands 2. Locate the fuse box under the hood 3. Open the fuse box 4. Locate the M7 fuse (Yellow 20) 5. Move the M7 to the next fuse cavity Bingo! You now have an “always on” port and you can test it now (remember you don’t need the key anymore). 1.
Why does the trunk lock actuator not work?
Another common signal that a problem with the trunk lock actuator exists is when you press the fob button or the inside trunk release and nothing happens. This might indicate a problem with the electronics running to the actuator such as a fuse or wire being shorted or an issue with the vehicle’s battery.
What should I do if my trunk lock is not working?
Occasionally the linkage may become damaged, or the electronic wire that is attached to linkage might come loose. If you notice that the trunk lock does not spring open when you press the fob remote or the button inside your vehicle’s cab, contact a mechanic so they can determine what is wrong and fix it as soon as possible. 2.
How does a trunk lock work in a car?
Today’s trunk locking mechanisms are comprised of a keyed lock cylinder and a trunk lock actuator in cars that offer a power trunk release once activated. The trunk lock actuator then releases the trunk latch so the trunk can be opened.
1. Remove the key from ignition and make sure you don’t have wet hands 2. Locate the fuse box under the hood 3. Open the fuse box 4. Locate the M7 fuse (Yellow 20) 5. Move the M7 to the next fuse cavity Bingo! You now have an “always on” port and you can test it now (remember you don’t need the key anymore). 1.
What can I use the rear outlet for?
Using the rear outlet to power a 12V Defroster/Heater, or small electronics could make a difference on the trail. Sometimes, you just want to use your Jeep for charging small electronics like a satellite phone, a tablet, a GPS, a pocket radio, weather instruments, etc. while you are not around.
Can you replace a 20 amp fuse with a 30 Amp Fuse?
1. DO NOT replace the 20-amp fuse with a 30-amp fuse: If you are plugging in a device that keeps blowing your fuse, replace the device (not the fuse). If you put a 25-amp or 30-amp fuse in the 20-amp cavity, there is a strong possibility that it eventually leads to heat and melted insulation because the wiring is only rated to handle 20 amps.
Can a 12V heater be used as a rear outlet?
Using your 12V rear outlet when the engine is off to power electronics, a 12V cooler bag or a 12V heater (for intermittent usage) exposes your battery to drain below cranking voltage. It’s a risk you may be willing to take on the trail but still a silly way to get stranded for good.
