How much fluid does a GM 4L60E need?
How much fluid does a GM 4L60E need?
The 4L60E transmission weighs 146 pounds dry, and 162 wet. It requires 8.4 quarts (9.64″ torque converter) or 11.4 quarts (11.81″ torque converter) of transmission fluid, Below is a list of common transmission problems with the GM 4L60E Transmission and possible solutions to repair.
When does the 4L60E go into overdrive?
It only does this at a narrow speed range at roughly 45-50mph at 1200-1300rpm. If I am driving faster (on the highway for example) and I hit a hill it doesn’t do it.
When did the GM 4L60 E transmission come out?
The 4L60-E is the “E”lectronically shift controlled version of the 4L60. The Late 4L60-E was released in 1997 in and fully phased into wide use through GM by 1998 in both RWD car platforms (including the C6 Corvette) and trucks in both 2wd and 4wd configurations.
Why is my Trans bad on my 4L60E?
Trans seems noisy when moving in 1st and Reverse, noise goes away instantly if you shift to N or the transmission goes into 3rd gear: Reaction planetary is worn out due to high miles or insufficient lubrication. Not a critical failure, but not a good sign either.
What kind of overdrive does a 4L60E have?
4L60E No Overdrive Diagnosis. The 4L60E is a for speed automatic transmission with a .70 overdrive. The overdrive gear is gear number four. As the 4L60E ages, one of the most common problems that it develops is that it won’t shift into overdrive anymore.
The 4L60E transmission weighs 146 pounds dry, and 162 wet. It requires 8.4 quarts (9.64″ torque converter) or 11.4 quarts (11.81″ torque converter) of transmission fluid, Below is a list of common transmission problems with the GM 4L60E Transmission and possible solutions to repair.
The 4L60-E is the “E”lectronically shift controlled version of the 4L60. The Late 4L60-E was released in 1997 in and fully phased into wide use through GM by 1998 in both RWD car platforms (including the C6 Corvette) and trucks in both 2wd and 4wd configurations.
Trans seems noisy when moving in 1st and Reverse, noise goes away instantly if you shift to N or the transmission goes into 3rd gear: Reaction planetary is worn out due to high miles or insufficient lubrication. Not a critical failure, but not a good sign either.
What are the most common 4L60E transmission problems?
No forward movement in OD or D, but L2, L1 and R work: Forward sprag is broken. Transmission must be removed and rebuilt. Try not to run or drive the car or further damage could result. 18. Extremely harsh shifts from P or N, normal shifts at WOT: EPC (Electronic Pressure Control) solenoid failed.
Why does my 4L60E have no reverse?
Slow, slipping or no reverse: “lo-reverse” clutches are worn out, fluid leak in the reverse apply circuit, or broken sunshell.
Why does my 4L60E make a horrible noise?
Horrible noise in 4th and feels like the brakes are on: overrun clutches are applying due to a cracked or leaking forward piston. Overrun clutches will be worn out after 30 seconds of this behavior. Car can be safely driven in D. Transmission must be removed and rebuilt.
Can a 1997 Chevy c1500 5.7L start?
1997 Chevy C1500, 2WD, 5.7L won’t start – cranks fine. No codes – good fuel pressure ( 60+ psi – new pump), good spark, 1997 Chevy C1500, 2WD, 5.7L wont start – cranks fine. No… It will not start. I changed the fuel filter and fuel pump It will not start.
Why does my 1997 Chevy Suburban not start?
1997 1500 pickup at low throttle engine is missing to the point were I had it full throttle and no power and engine died. Still won’t start … read more Vocational, Technical or Tra… i have a 1998 chevy suburban. It was running fine when parked, but 3 days later will not start. It cranks fine, but sounds as though it wants … read more
What kind of engine does a 1990 Chevy c1500 have?
My 1990, 2WD, C1500 chevy truck is acting weird on the highway. When I get in between 40 and 60 MPH the truck acts like it is mis-firing. The truck runs great when I accelerate or run at higher RPM. I … read more
How much does a 4L60E transmission weigh?
The 4L60E Transmission has went through many changes/improvements over the years since it first came out in 1982. From bells to valve bodies, added solenoids, changes in pump and convertors. The 4L60E transmission weighs 146 pounds dry, and 162 wet.
What should the Trans be on a Cummins 6CTA?
Maybe slide the stocker first, and see where it gets you. For those power numbers (after the gauge install), do a #10, 100, or 0 plate, 3k gov spring kit, advance the timing to about 15-16, maybe 17, and maybe do something with the trans (if it’s going to be close to max input rating). But that’s just a suggestion.
How many liters does a Cummins RV have?
Anyways the boat and trailer is in the 5-6K pound range, and on the mountain passes going to the coast my dad wasnt very impressed with the performance of the RV. So it has a 300hp Cummins 8.3 6CTA. Basically from my understanding its just a cummins 5.9 just 8.3 liters.
How many liters does a Cummins 5.9 diesel have?
So it has a 300hp Cummins 8.3 6CTA. Basically from my understanding its just a cummins 5.9 just 8.3 liters. Its a 1997 model, and the motor is mechanical sly: ).
What happens when you turn up the diesel in a Cummins?
The diesel smoke from a turned-up diesel will get soot all over your trailer or vehicle in tow. It will increase EGT’s and you’ll end up taking your foot off the go pedal on mountains. If you must let off the pedal to keep EGT’s in check, then what gain have you made?