Can a Datsun 120Y be fitted with an A14 engine?

Can a Datsun 120Y be fitted with an A14 engine?

Another method of modifying the mounts is to bolt a steel plate to the mounts on the A14 block, and also bolt it to the rubber mounts on the cross member. The A14 engine will fit into a 120Y with no modifications to the engine mounts.

Where are the adapters on a Datsun 1200?

Engine mount adapters were manufactered, to sit between the rubber mount and the cross member bracket. Phil used the right side A12 engine mount bracket on the left side of the A15, and the stock A15 right side bracket. The A12 flywheel/flexplate bolts right onto the A15, as does the crank spacer.

Can a flywheel be removed from a Datsun 1200?

The A12 flywheel/flexplate bolts right onto the A15, as does the crank spacer. There is no need to remove the standard gearbox input shaft bushing, as the spacer is designed to accept the A12 torque converter nipple.

What kind of cylinder head does Datsun B10 have?

B10 Coupe with A10 engine had different part number. It is unknown how it differs from the regular Datsun 1000 cylinder head. It is fitted with flattops pistons (same as the Hi-Gas A12GX pistons), and a dual-outlet exhaust manifold.

Can you put an A14 engine in a Datsun 1200?

The engine mounts of the A14 are in a different position on the block than on the A12. I believe that you can put a 120Y cross member into a 1200, and then the A14 will drop straight in. According to Mikko , you will need to move the crossmember mounts outward slightly as the bolt spacing on the 120Y is different to that on the 1200.

Is the Datsun GX the same as the A12?

Datsun 1200 pipe is straight out. The block crank and rods are the same as the standard A12. The GX engine uses a twin-carb inlet manifold with extra-large oval ports to match the cylinder head. a matched pair of left- and right- hand Hitachi HJE38W carbs.

Where are the casting numbers on a Datsun 1200?

USA FED A12/A14/A15 round port, wet intake, new bolt pattern. Has round intake ports (like the A12 head). Casting numbers are under the valve cover area: “990” towards the rear and “454” towards the front. These cannot be ported out to match the oval port heads (you’ll hit a water jacket).

What kind of cylinder head does a Datsun have?

The A14/A15 Oval-port Heads include large 37 mm intake valves and 30 mm exhaust valves. These heads first appeared with the 1975 A14 engine. Open Chamber versions can can be milled .080″ or more to raise compression. Oval-Port heads include: H72: Dry, Large Oval, Open Chamber. The original A14 head, designed for USA market. With Air Pump passage