Why does my 2002 corvette stay in neutral?

Just bought a 2002 coupe and noticed that the passenger tempeture control knob doesn’t change the temperature display when you turn the knob up or down. … Pulled corvette into garage-activated trunk release-corvette stays in neutral when i try to shift-will not work in drive or reverse-closed trunk;still …

Why are the headlight doors on my C5 Corvette not closing?

The headlight doors on my C5 corvette wont close with the engine turned off. Is this normal? Just bought a 2002 coupe and noticed that the passenger tempeture control knob doesn’t change the temperature display when you turn the knob up or down. …

Why is my Blend door not working on my Corvette?

Check for proper installation or take your Corvette to whoever installed the head unit, if all is connected properly then the head unit was bad to begin with. If you are having inconsistent airflow issues, you could be experiencing out of sync blend door problems. This is a pretty simple fix.

Are there any problems with my 1999 corvette?

Hello, this is just the latest of problems with what I think is the muiltfunction switch turn signals work at times other not, when cruise control is activated … 1999 Corvette, The TPS and the Key-fobs are not being received by the transceiver. tried a different receiver still nothing. they did work when i got the …

How do you remove the dash from a corvette?

Pull the panel up and towards the front of the car. Notice that there is a connector, two 10mm hex head bolts, and an auxiliary power port connector to remove from this area. Open the console door and locate the two plastic inserts covering the 10mm nuts. Pry them off with the plastic wedge. Remove the 10mm hex head nuts with a 10mm socket.

How do you remove photo sensor from Corvette?

Remove the 7mm screw on the left side of the dash. Pop up the defroster vent with a flathead screwdriver to access the photo sensor. Gently twist the connector to remove it. There are two sensors, sun load and ambient light, one on each side. Remove the two 7mm screws at the top of the dash.

How do you remove head nuts from Corvette?

Open the console door and locate the two plastic inserts covering the 10mm nuts. Pry them off with the plastic wedge. Remove the 10mm hex head nuts with a 10mm socket. Remove the Phillip’s head screw adjacent to the cigarette lighter.

How to ask a question about a C5 Corvette?

Below you can find an entry form to C5 Ask Corvette Garage Talk. You can submit a question about problems you have with a C5 Corvette. Also you can Respond to other peoples questions.

Why did my 1999 C5 Corvette not start?

1999 Corvette, The TPS and the Key-fobs are not being received by the transceiver. tried a different receiver still nothing. they did work when i got the … 1999 C5 corvette died after starting 3 times after I put it in gear.

Can a C5 Corvette work in reverse release?

Pulled corvette into garage-activated trunk release-corvette stays in neutral when i try to shift-will not work in drive or reverse-closed trunk;still … C5 with a psi gauge on 80 with engine running, can I reset the gauge. Year2001 My 03 C5’s cruise disengages.

What to do when your Corvette C5 wont start?

Pull the correct fuses (found in the owners manual) and reset the codes. If that doesn’t work you can try this little trick: set the heat on high, shut the car off, discount the battery on the negative side, wait five minutes, reconnect and see if your problem has gone away.

Are there any problems with the corvette head unit?

Why is my climate control not working on my Corvette?

It’s common for vacuum hoses to crack, split, fall off their connections, or even during the process of repairing something else, a hose gets taken off but never gets put back on. Without proper vacuum, you won’t get the pressure you need to run your climate control properly.

How many ground points does a C5 Corvette have?

Your C5 Corvette comes with 13 different chassis ground points around the car, all of which are subject to corrosion or coming loose causing a bad connection. If you are having electrical problems that can’t seem to be solved by anything else, you should do a chassis ground clean.

Why does my C5 Corvette not start hot?

c5 won’t start hot unless the key is cycled between off and on three times, then it will run fine. fuel pressure regulator has been changed as well as … The headlight doors on my C5 corvette wont close with the engine turned off. Is this normal?

When do you push the start button on a corvette?

Starting is, thereby, instantaneous as soon as as the driver gets his/her butt adjusted and pushes the button. Thanks, that helps a lot. In addition, you only briefly depress the button which actuates the starter sequence. The starter turns until the engine cranks whether you are pressing the button or not.

When did they stop putting dates on corvette build sheets?

In 2006 the Assembly Plant quit putting dates of any type on the build sheet. Prior to that, the date on the build sheet was NOT the date the car was built, but the date the order was entered for production. It has been reported that it took 7-10 working days from the time the order was entered until the Corvette rolled off the production line. Q.

Below you can find an entry form to C5 Ask Corvette Garage Talk. You can submit a question about problems you have with a C5 Corvette. Also you can Respond to other peoples questions.

What happens when a cruise control switch fails?

If the cruise control switch fails, it will not be able to deactivate the cruise control system when the brake pedal is depressed. This will cause the vehicle to continue to accelerate as the brakes are being applied, which can cause them to overheat and damage the components.

Is there a problem with my 99 C5 Corvette?

Have a ‘99 C5 that the battery went dead in, after recharging battery the instrument cluster keep going thru intermittent cycles saying Service ABS, Service … Hello, this is just the latest of problems with what I think is the muiltfunction switch turn signals work at times other not, when cruise control is activated …

What happens when you disengage the cruise control?

Just as you uncurl your feet and try to accelerate back to traffic speeds, the vehicle downshifts with a lurch and abruptly climbs back to over 80 mph. So you tap the brakes and disengage the cruise control to avoid a conversation with one of the many law enforcement officers lurking behind every other billboard.

Can a bad brake release switch cause a bad cruise control?

One of the symptoms commonly associated with a bad cruise control brake release switch is a cruise control system that cuts off unexpectedly. If the switch has any sort of contact or internal issues, it may cause the cruise control system to cut off unexpectedly when activated, even if the pedal is not stepped on.