Where are the brakes on the passenger side?
Where are the brakes on the passenger side?
On the driver side, one bolt is used, located out-of-sight, behind and above the primary brake. On the passenger side, the brake attaches with one self-tapping screw or bolt. How much room does the brake take up? In most vehicles, our brakes provide adequate room for feet to rest comfortably on the floor (in front and to the left of brake).
What causes rear wheel to lock up when braking?
Problem: One or both rear wheels lockup during braking or the rear end of the car squats when braking. Cause: Rear Wheel lockup or squatting has many causes. Here is the list of possible causes: Service and parking brake adjustment. Rear brake hardware. Shoe lands or bosses. GM clip in wheel cylinders. Brake drum condition.
Can a out of round brake drum cause one wheel lockup?
An out of round brake drum or drums that vary in diameter too much from side to side could cause a one wheel lockup condition (Figure 61.8). Measuring drum runout or out of roundness is not easy in the field. Current micrometers do not allow a repeatable measurement to be taken.
When to use handbrake or front brake caliper?
The handbrake prevents the car from rolling when the car is at a complete halt. In extreme circumstances, the driver can use the handbrake to stop the car when the brakes fail. The front brakes often play a greater role in bringing the car to a halt than the rear ones. This does not mean you should replace one and ignore the other.
What causes rear wheel lockup on Phoenix brakes?
The shoe lands or “bosses” are an often overlooked item when looking for the cause of a rear wheel lockup condition. The shoe lands keep the brake shoes square with the drum and provide a friction surface for the shoes to move against. Over time the bosses can become grooved and corroded as in Figure 61.6.
The handbrake prevents the car from rolling when the car is at a complete halt. In extreme circumstances, the driver can use the handbrake to stop the car when the brakes fail. The front brakes often play a greater role in bringing the car to a halt than the rear ones. This does not mean you should replace one and ignore the other.
An out of round brake drum or drums that vary in diameter too much from side to side could cause a one wheel lockup condition (Figure 61.8). Measuring drum runout or out of roundness is not easy in the field. Current micrometers do not allow a repeatable measurement to be taken.
What to do if your rear brakes keep locking up?
If you take the rear drums off put just a dab of grease on all the metal to metal contact areas for smooth operation, just a dab. You might also try flushing the brake system since the fluid may have crap in it that could be causing issues. I’m pretty sure it’s just the passenger side.
