What was the problem with my tractor engine?
What was the problem with my tractor engine?
Collapsed radiator hose. Thermostat stuck. Engine overloaded. Diluted lubricating oil. Pulling heavy load at reduced RPM. Water pump impeller vanes broken.
What causes loss of compression in a tractor?
Loss of compression. Dirty nozzles. Battery charge low. Valve clearance incorrect. Fuel transfer pump faulty. Fuel injection pump faulty. Fuel injection pump out of time. Low water level in cooling system. Radiator clogged.
What does white exhaust mean on tractorforum Cal?
Welcome to TRACTORFORUM Cal! 1)- The fine, white exhaust is typically, coolant diluted with fuel in the YM240’s combustion chamber. 2)- The duration of time for the symptoms to occur indicate the engine coming up to temperature (1/2 hour), which, again, indicate a blown head-gasket and warped head.
How can I improve the operation of my tractor?
You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment.
Why is my cat 320C excavator engine stalling?
I have been having a lot of trouble with a CAT 320C Excavator (S/N BDE00683) with 16 000 hours on the clock, which my boss just bought. The excavator is well serviced, engine looks and works well, but when under load, the engine revs go down very fast, it stalls and there is no hydraulic power. I can excavate only with the tip of the bucket.
Why does my tractor lose power at high RPM?
The following is a letter Bohacz received from Steve Meyer: My two-cylinder diesel tractor Belarus AS250 is having a problem that I am trying to diagnose. When running at low or medium RPM, the tractor seems to have full power. But when running at high RPM, the tractor experiences loss of power.
How much hydraulic power does a cat 320C have?
I followed the instructions from CAT and I should have measured 0,2 to 0,75 Amperes at the Solenoid input and 4,8bar (70 psi) to 34,5 bar (500 psi) pressure at the tap. However, for the electricity I get 0,14 to 0,5 Amps and for the pressure I get 4bar (58 psi) to 22 bar (319 psi).
Why does my excavator stall when under load?
The excavator is well serviced, engine looks and works well, but when under load, the engine revs go down very fast, it stalls and there is no hydraulic power. I can excavate only with the tip of the bucket. If I try deeper, it stalls. It also happens with every other movement.
