Easy lifehacks

Is the 10 Amp Fuse on my heater fan burned out?

Is the 10 Amp Fuse on my heater fan burned out?

The 10 amp fuse was not burned out. The blower motor resistor was a little rusty.I inspected and found no burned or melted wires anywhere , at the inside three way dash switch , at the blower motor and at the resistor.I know the air bag is tied into the same fuse , I must have replaced the fuse 12 times .

What should I do if my heater fan doesn’t work?

Replaced 10 amp fuse , blower relay,blower motor,dash s dash switch and switch out under the hood relays. Seems no power to anything when checked with a test light. Blower motor *resistor* been tested? ..

Where is the blower fuse on a Dodge?

Dodge owners manual shows the 40 amp blower fuse, #25, but does not mention any blower relay in the PDC. All the relays in the PDC have designated legends on the cover, but none indicate they are for the front blower relay. Haynes also states this blower relay is powered via a fuse in the junction box from under the dash, #12, 10 amp.

Is there a problem with the heater motor?

The heater motor uses a chassis connection close to the motor. It is worth checking that this is not loose or otherwise faulty. 5. For testing a 12V test lamp is useful, as it can prove a circuit through the motor etc., while a modern multimeter can be misleading due to its high sensitivity giving a reading through a faulty connection.

The 10 amp fuse was not burned out. The blower motor resistor was a little rusty.I inspected and found no burned or melted wires anywhere , at the inside three way dash switch , at the blower motor and at the resistor.I know the air bag is tied into the same fuse , I must have replaced the fuse 12 times .

Replaced 10 amp fuse , blower relay,blower motor,dash s dash switch and switch out under the hood relays. Seems no power to anything when checked with a test light. Blower motor *resistor* been tested? ..

Dodge owners manual shows the 40 amp blower fuse, #25, but does not mention any blower relay in the PDC. All the relays in the PDC have designated legends on the cover, but none indicate they are for the front blower relay. Haynes also states this blower relay is powered via a fuse in the junction box from under the dash, #12, 10 amp.

What should I do if my furnace is not working?

General Furnace Maintenance. For starters, once a year, vacuum out the area around the furnace’s blower. If possible, also slide out the fan unit, clean each fan blade with a toothbrush, and then vacuum with a brush attachment on a vacuum cleaner.

How many times should I replace the fuse on my air conditioner fan?

The blower motor resistor was a little rusty.I inspected and found no burned or melted wires anywhere , at the inside three way dash switch , at the blower motor and at the resistor.I know the air bag is tied into the same fuse , I must have replaced the fuse 12 times .

What to do when your AC Fan is not working?

Checked for incoming resistance ground to the blower, from the dash control switch and it works. Checked for battery at the blower, when the car is running. There is no battery to operate the blower. Rotated all the PDC relays around, they have the same ID, other than ABS pump.

What happens when a car fan is not working?

That means a trickle out of your vents instead of the rush you asked for. When it does happen, you’re left with a miserably underpowered heat or AC system. It will still work with no fan, and you’ll usually still be able to control the temperature of the air that is blowing or trickling, out.

Why is my a / C blower not blowing?

A metal that when it corrodes, it turns white, and unlike copper, aluminum corrosion does not conduct electricity at all and causes resistance issues and can cause overheating of a circuit. Took out a common finger nail Emory board and went to work, both sides of each contact, then used a small brass brush on each side and along the tips.

What happens when there is no AC or heat?

When it does happen, you’re left with a miserably underpowered heat or AC system. It will still work with no fan, and you’ll usually still be able to control the temperature of the air that is blowing or trickling, out. But a climate control system with no fan to push the air around is anything but controlled.

What happens when you change the fuse on a blower?

If the blower works when you change the fuse, you may not be out of the woods yet. When the motor gets old and tired it will draw more current through the wires than a new motor.

What causes a bad or failing blower motor relay?

Blown fuses. One of the first symptoms of a bad or failing AC blower motor relay is a blown AC blower motor relay circuit fuse. If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current…

When to replace a heater blower motor switch or relay?

When the motor gets old and tired it will draw more current through the wires than a new motor. It may still draw enough current to blow the fuse after it runs for a while. In that case, a motor replacement is in order. Step 1: Disconnect the battery. Put on your safety glasses and disconnect the battery at the negative cable.

What causes a fuse to blow on a blower motor?

If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.

Blown fuses. One of the first symptoms of a bad or failing AC blower motor relay is a blown AC blower motor relay circuit fuse. If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current…

What are the symptoms of a blown fuse or relay?

One of the first symptoms of a blown fuse or relay is an illuminated ABS Light. The ABS Light will become illuminated once the computer has detected that there is a problem with the system. If a fuse blows, or a relay fails, the computer will pick up the signal and activate the Check Engine Light to alert the driver that a problem has occurred.

Is there a fuse for the air bag indicator?

There are two fuses, one for the air bag indicator, and the other for the air bags. I have heard that pulling the “air bag ind” fuse will not affect whether or not the actual air bags will go off in a crash, and it sure is nice not to see that “air bag” light on the dash.

There are two fuses, one for the air bag indicator, and the other for the air bags. I have heard that pulling the “air bag ind” fuse will not affect whether or not the actual air bags will go off in a crash, and it sure is nice not to see that “air bag” light on the dash.

How can you tell if a Honda Civic has a blown fuse?

Determine from the chart, or the diagram on the fuse box lid, which fuse or fuses control that device. Check those fuses first, but check all the fuses before deciding that a blown fuse is the cause. Replace any blown fuses, and check if the device works. Turn the ignition switch to LOCK (0).

Where is the power plug mini fuse located?

– A Rear Power Plug mini fuse (Panel Van Only) is located near the battery in the rear of the vehicle. How to check the fuses? How to replace a blown fuse? Why do car fuses blow?

Where is the fuse located on a Dodge Ram?

– The Left Rear Access Panel Door Relay (Panel Van Only), and the Right Rear Access Panel Door Relay (Panel Van Only) are located in the rear of the vehicle behind the right rear quarter trim panel. – A Rear Power Plug mini fuse (Panel Van Only) is located near the battery in the rear of the vehicle.

Author Image
Ruth Doyle