How do you set your headlights for mot?

Adjust the headlights by loosening the screws and manually moving the bulb by hand. Ensure that the lights are turned off whilst doing this, then turn them on to see if you have adjusted them to the correct position.

How do you adjust the beam of a headlight?

Block one of the headlights and look to see where the other beam hits the wall. It should fall at or below the horizontal tape line you marked and to the right of the vertical tape line. If it doesn’t, use the adjusters located on the headlight housing to adjust the beam until it hits the right spot on the wall.

How do you adjust the headlamp on a Hella?

Correct the headlamp adjustment if necessary using the adjustment options. Align device according to point 4.0. Set the scaled wheel according to the adjustment table. The light beam center of the high beam must be on the central marking; correct if necessary using the adjustment option.

Where do you Put Your Headlights on the aiming wall?

The front of your headlights should be 25 feet from the aiming wall chart you’ve created. Turn on your lights: Turn off your garage lights or any other light source and turn on your vehicle’s headlights to compare their alignment to the guide. If you’re adjusting your headlights outside, you’ll need to do this work at night.

Where do you put the adjuster on the headlight?

These screws are typically found adjacent to the headlight, though some manufacturers put the screws in the engine compartment, behind the the headlights. The horizontal adjuster and the vertical adjuster should be marked. Always defer to the specs in the owner’s manual—some manufacturers recommend different distances for proper adjustment.

What is the best way to adjust headlights?

Adjust the headlights one at a time. You can raise or lower the headlamps by turning the screw on the top of each light clockwise and anticlockwise, respectively. Keep turning the screw until the brightest part of the light beam falls directly on or just below the tape line center on the wall.

How high to adjust headlights?

Turn the top adjustment screw on the headlights clockwise to raise the beam and counterclockwise to lower the beam. Adjust the headlights so the beam height is two to four inches below the horizontal cross of masking tape. Turn the side adjustment screw to adjust the center of each headlight from side to side.

What is a headlight adjustment?

Proper headlight adjustment is a necessary safety measure because if they are not aligned right, you won’t get the full visibility while driving at night. Besides, misadjusted headlights don’t illuminate the road directly in front of you, causing blinding the eyes of oncoming drivers instead of shining the roads.