Can you change brakes without resurfacing rotors?
Can you change brakes without resurfacing rotors?
If the brake discs are still smooth they may not need to be resurfaced, but most professional brake mechanics will not install new brake pads without resurfacing the rotors. Resurfacing restores a flat and even surface that minimizes vibrations and allows for maximum brake pad friction.
What kind of brakes does a Dodge Ram have?
Your Dodge Ram’s brakes tend to work a little harder than most average vehicles. You want to make sure the brakes are fresh so it can keep working just as hard. This article applies to the Dodge Ram (2002-2008). The brakes on your Dodge Ram tend to take quite a beating.
How do you replace brake pads on a Dodge Ram?
Most new pads come with new anti-rattle clips. Either way, if you keep or replace them, you will want to apply some grease to them to help the pads slide easily in them. Figure 8. Remove the brake pads. Figure 9. Apply grease to the anti-rattle clips. Now that you have the pads and caliper removed and out of the way, you can remove the brake rotor.
Why are the brakes on my Dodge Ram so bad?
The brakes on your Dodge Ram tend to take quite a beating. This is in part due to the fact that trucks usually work a bit more than most other vehicles. They are also usually used a bit harder and rougher than most other vehicles.
How do you remove the caliper from a Dodge Ram?
To completely remove the caliper, you will need to loosen the banjo bolt that secures the rubber brake line to the caliper (Figure 7). This will be the only thing keeping it attached to the vehicle at this time. When you loosen this bolt, brake fluid will leak out, so be prepared to catch it with a suitable container.
How do you remove brake rotors on a Dodge Ram?
While removing the brake rotors was basically the same for the 1/2-ton and 3/4 ton Rams, the 1-ton version added a slightly different procedure. Lift the Dodge Ram on a vehicle or truck lift to a suitable height to work on. Remove the lug nuts using an impact gun and a 7/8-inch impact socket or a 22 mm impact socket.
When to pump the brake pedal on a ram?
Be sure to pump the brake pedal once the Ram is back together to restore the compressed caliper piston to its seated position. Otherwise there will be no braking response until the pistons extend outward from the caliper piston bore. This, however, can cause a serious accident if there are any nearby obstacles.
How do you remove rotor from wheel hub?
Pry the caliper and pad assembly off the rotor and support it to the suspension using a caliper hook or metal hanger. Remove the caliper adapter bolts using the impact gun and a suitable socket. Remove the adapter. Remove the rotor from the wheel hub assembly.
How do you remove a caliper from a rotor?
Disconnect the two caliper bolts using a hand wrench. Pry the caliper and pad assembly off the rotor and support it to the suspension using a caliper hook or metal hanger. Remove the caliper adapter bolts using the impact gun and a suitable socket.
