Why does my Salt Cell say no flow?

Why does my Salt Cell say no flow?

The “No Flow” light indicates that the flow switch is not detecting sufficient water passing through. Check the following: cleaning the cell or the filter (see how to backwash a DE Filter or Clean a Cartridge Filter). Replace the flow sensor.

How do I reset my Hayward Salt Cell?

To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.

How do I know if my Hayward Salt Cell is working?

The easiest way to be certain if the chlorinator is working is to make sure the cell is clean by checking the needle or production lights on the chlorinator box. When operating, you should also see bubbles (hypochlorite gas) inside the chamber, producing what looks like cloudy water – that’s chlorine being created!

What does no flow mean on Hayward Aquarite 900?

“No Flow” LED illuminated. The Hayward Aqua Rite has sensed a no flow condition and has stopped generating chlorine. If there is adequate flow and the LED is still on, check that the arrows on the flow switch (on top of hex) are pointing in the direction of flow.

How do I know if my Hayward switch is bad?

”No Flow” light coming on probably means the cell’s flow switch has gone bad. Verify that the pump is running first (water is actually flowing through the line). If “No Flow” stays on the flow switch needs replacing. ”Flow” LED turning from green to red means water flow through the system has been disrupted.

How do I know if my salt cell is bad?

Further troubleshooting will be required.

1. If the salt cell bubbles, but only a little bit, then you probably have a bad cell.
2. If the salt cell bubbles vigorously, then it is working fine.
3. If the salt cell is good, but you are are constantly getting a zero chlorine reading in the pool, something else is wrong.

How do you fix a no flow pool pump?

If your pump looks like there is no water in it, turn it off and unscrew the pump lid without losing the o ring. Fill up a bucket with pool water and pour it into the pump, this is called priming. Once the water level reaches the top, replace the pump lid with the o ring and turn your pump back on.

What does Hayward flow switch do?

The flow switch is a safety device that ensures that water is flowing through the cell before the salt system will generate chlorine. The flow switch should be located in a PVC T and the arrow needs to be pointed the same direction as the water flow.

How do you test a Hayward flow switch?

You can test the continuity of the flow switch using a Voltmeter or Ohmmeter. Continuity is open if there is no flow. Alternatively, continuity is close if sufficient water flow is detected.