Where is the knock sensor on a 2004 PT Cruiser?
Where is the knock sensor on a 2004 PT Cruiser?
The knock sensor is located on the front of the engine block, under the intake manifold.
Where is the knock sensor on a 2005 pt cruiser?
It is located below intake manifold, in front of your oil dip stick. It will be screwed into the front of the block.
Where is the knock sensor on a car?
This means the PCM has detected a problem with the knock sensor or its circuit. Some vehicles may be equipped with two knock sensors. Code P0325 pertains to the sensor on bank 1 (the side of the engine where the #1 cylinder is located).
What are the problems with a 2007 PT Cruiser?
Unfortunately, engine lights that will not turn off seem to be a prevalent PT Cruiser problem. The common symptoms for the 2007 PT Cruiser are overheating accompanied by the engine light turning on. The code P0340 is often displayed as the problem for owners.
What does the code p0340 mean on a PT Cruiser?
The common symptoms for the 2007 PT Cruiser are overheating accompanied by the engine light turning on. The code P0340 is often displayed as the problem for owners. This code means that the camshaft position sensor circuit sensor A bank 1 is malfunctioning. As we will see below this code makes sense since replacing the camshaft fixes the problem.
Why does my PT Cruiser stall while driving?
This is the most dangerous of the PT Cruiser problems. It involves the engine to completely stall out while driving. It can happen sporadically while driving, giving the driver no warning as to when it will happen next. For some drivers, the issue occurs when a certain RPM is achieved. For others, the problem occurs at a certain speed.
Why does the engine light come on on a PT Cruiser?
The following steps can be employed reset the light on a PT Cruiser. Also identified are some common problems that cause the engine light to come on. Check the gas cap on your PT Cruiser to ensure it is tightened properly. Shack the cap lid and listen for a rattle, if one is present, replace it.
Unfortunately, engine lights that will not turn off seem to be a prevalent PT Cruiser problem. The common symptoms for the 2007 PT Cruiser are overheating accompanied by the engine light turning on. The code P0340 is often displayed as the problem for owners.
The common symptoms for the 2007 PT Cruiser are overheating accompanied by the engine light turning on. The code P0340 is often displayed as the problem for owners. This code means that the camshaft position sensor circuit sensor A bank 1 is malfunctioning. As we will see below this code makes sense since replacing the camshaft fixes the problem.
Where is the negative battery on a PT Cruiser?
Open the hood and locate the battery found in the front right, directly behind the passenger headlight assembly. Remove the negative battery terminal cable by using an adjustable wrench to loosen the cable latch. Put on the leather gloves and grab the cable, twisting it back and forth until it’s loose enough to remove.
