Where is the fuel filter located on a 1998 Toyota 4Runner?

Where is the fuel filter located on a 1998 Toyota 4Runner?

Trace the fuel lines until you locate the fuel filter. You should find it below the driver-side door, attached to the frame.

How do you change a fuel filter on a Toyota 4Runner?

1. Step 1 – Disconnect negative battery terminal. Disconnect the negative battery terminal, then wrap it in a towel to avoid any contact with metal.
2. Step 2 – Remove fuel filter. Before removing the air filter, some forum enthusiasts like to remove the gas cap to depressurize the system.
3. Step 3 – Install new filter.

Do you have to replace the fuel filter on a Toyota 4Runner?

If you have ever had a fuel filter clog up and the flow of fuel stop, you know that you are not going anywhere. Toyota claims that the OEM fuel filter does not have to be replaced until you replace the engine. Once you see where the filter is located on a four cylinder engine, that is comforting since it can hardly be seen.

How do you remove a fuel line nut?

Locate the fuel filter under the driver’s door, along the frame rail. Then, use your wrench to remove the two fuel line nuts on each side of the filter. Pull the lines off, then remove the two bolts holding the filter in place. Figure 3. Disconnect two line nuts and two bolts on top.

How much does it cost to change fuel filter?

Its pretty simple to do. All you need is a basic wrench set. (The largest you’ll need is a 19mm) and the filter itself. The filter was 30-35 bucks at my local auto parts store. Having a clean fuel filter increases your Miles Per Gallon that your vehicle gets. Leave any questions in the comments and make sure to like the video if it helps you!

How do you change the fuel filter on a banjo?

Hold the 17mm nut on one end, the filter with an open end wrench, and then use a 14mm socket to loosen the banjo fitting. It will be tight with little room to work. Fuel will leak when the fitting is loosened. Then, do the same to the other end of the filter. Access mounting bolts from the passenger wheel well.

Where is the fuel filter on a Toyota 4Runner?

However, the Toyota engineer who located the fuel filter on the truck/4Runner certainly had a robust sense of humor: the filter is located on the passenger side inner frame rail right at the rear torsion bar mount. Never mind that there’s 18″ of open frame rail just behind this location….. Well, I guess it is well-protected when wheeling.

Where is the fuel filter located in a car?

The most common location for modern vehicles is along the fuel line on the bottom of the car, just past the fuel pump. In some vehicles, the fuel filter is located in the engine bay on the line that leads to the fuel rail.

What do you need to replace fuel filter in Toyota?

To replace it, all that is needed is a 14mm box wrench for the fuel lines, a 12mm socket for the filter mounts, some rags, and a drain pan. IMPORTANT! This EFI engine retains fuel pressure at all times.

Locate the fuel filter under the driver’s door, along the frame rail. Then, use your wrench to remove the two fuel line nuts on each side of the filter. Pull the lines off, then remove the two bolts holding the filter in place. Figure 3. Disconnect two line nuts and two bolts on top.