Where can I get an axial piston installation drawing?
Where can I get an axial piston installation drawing?
Please request the installation drawing via your contact person at Bosch Rexroth. Installation drawing Product-Specific Operating Instructions Contains special information for the axial piston unit concerned. Ask your responsible contact person at Bosch Rexroth for a product- specific instruction manual for your axial piston unit.
What’s the best way to install a piston?
If you need excessive force to push the piston through the ring compressor into the bore, it usually means the oil ring expander rails are overlapped. Rotate the engine on the engine stand. Coat the bearing in the rod cap end with assembly lube and install.
How to remove a piston from an engine?
Place a support on the cylinder mounting pad and secure it with two cap-screws or nuts. Then, remove the piston and ring assembly from the connecting rod. A pin pusher or puller tool can be used when varnish makes it hard to remove the pin.
How to install hypereutectic pistons on a rod?
1. USE HIGH QUALITY ASSEMBLY LUBE. NEVER USE GREASE. 2. PRESS FIT, USE ROD HEATER. 3. DO NOT USE LOCKS WHEN DIMPLE DIMPLE SHOULD BE PLACED THE OIL GROOVE. THE RAISED SECTION SHOULD BE PLACED FACING DOWN. SPACER RING THE SPACER RING SUPPORTS THE OIL RAIL ON LONG ROD APPLICATIONS WHEN THE WRIST PIN IS INTERSECTING THE OIL GROOVE.
How do you remove a piston engine cylinder?
Plug or cover openings in the intake or diffuser section. Then, remove cylinder deflectors and any attaching brackets that would obstruct cylinder removal. Loosen the spark plugs and remove the spark plug lead clamps. Do not remove the spark plugs until ready to pull the cylinder off. Remove the rocker box covers.
How does the kx033-4 control lever work?
When KX033-4 control levers are in neutral for more than 4 seconds, engine RPM automatically idles. Move any control lever, and engine RPM immediately returns. This innovative feature not only lowers noise and exhaust emissions, but also reduces operating cost and fuel consumption. It can be turned on and off. SUPERIOR PERFORMANCE Front Bush Pins
Can you leave the cylinder head on a KX500?
You can optionally leave the cylinder head on the cylinder (eliminates the need for head gasket change). Note that it is harder to properly inspect and clean the cylinder this way. If you never have inspected your cylinder before, you really should lift the head.
How to install a piston in an aircraft engine?
Install the piston and ring assembly on the connecting rod. Be sure that the piston faces in the right direction. The piston number stamped on the bottom of the piston head should face toward the front of the engine. Lubricate the piston pin before inserting it.
