Where are the connectors on a Dodge Nitro?
Where are the connectors on a Dodge Nitro?
A single integral connector receptacle (4) is located adjacent to the antenna ring on the SKREEM housing. An integral molded plastic mounting tab (2) on the SKREEM housing has a hole in the center through which a screw passes to secure the unit to the steering column lock housing.
What to do if your Dodge Nitro wont start?
DIAGNOSIS: 1. With the condition present (i.e. the vehicle in the no crank / no start condition), connect the StarSCAN (R) scan tool to the vehicle. 2. Turn the ignition switch to the “ON position, and power up the StarSCAN (R).
Where is the Sentry Key on a Dodge Nitro?
Position the Sentry Key REmote Entry Module (SKREEM) (3) onto the steering column ignition lock housing with the antenna ring oriented around the lock cylinder (5). 2. Install and tighten the screw (2) that secures the SKREEM mounting bracket to the boss on the top of the ignition lock housing. Tighten the screw to 2 Nm (20 in. lbs.).
How to reset the WCM on a Dodge Nitro?
If the WCM is electronically locked up, the StarSCAN (R) will display the WCM as being “off bus”. f4. If the no crank / no start condition is present, and the WCM is “off bus”, then reset the WCM by temporarily removing the IOD fuse (with the key out of the ignition switch), wait for 10 seconds and then reinstall the IOD fuse.
A single integral connector receptacle (4) is located adjacent to the antenna ring on the SKREEM housing. An integral molded plastic mounting tab (2) on the SKREEM housing has a hole in the center through which a screw passes to secure the unit to the steering column lock housing.
Position the Sentry Key REmote Entry Module (SKREEM) (3) onto the steering column ignition lock housing with the antenna ring oriented around the lock cylinder (5). 2. Install and tighten the screw (2) that secures the SKREEM mounting bracket to the boss on the top of the ignition lock housing. Tighten the screw to 2 Nm (20 in. lbs.).
DIAGNOSIS: 1. With the condition present (i.e. the vehicle in the no crank / no start condition), connect the StarSCAN (R) scan tool to the vehicle. 2. Turn the ignition switch to the “ON position, and power up the StarSCAN (R).
If the WCM is electronically locked up, the StarSCAN (R) will display the WCM as being “off bus”. f4. If the no crank / no start condition is present, and the WCM is “off bus”, then reset the WCM by temporarily removing the IOD fuse (with the key out of the ignition switch), wait for 10 seconds and then reinstall the IOD fuse.
Where is The Skreem located on a Dodge Nitro?
The SKREEM is located on the right side of the steering column near the ignition lock cylinder housing and is concealed beneath the column shrouds. The molded black plastic housing for the SKREEM has an integral molded plastic halo-like antenna ring (1) that extends from one side.
The SKREEM is located on the right side of the steering column near the ignition lock cylinder housing and is concealed beneath the column shrouds. The molded black plastic housing for the SKREEM has an integral molded plastic halo-like antenna ring (1) that extends from one side.
How does the MAP sensor work on the intake manifold?
This sensor detect the intake manifold pressure change value and converts it into a signal voltage. Get the scoop on the MAP sensor from an electronic point of view and towards reading wiring diagrams. Presented using advanced software CG animation technology to help you understand.
