When does Chevy pick up turn signal fuse blow?
When does Chevy pick up turn signal fuse blow?
Mostly starts past 30mph. Transmission is off the Suburban now. Whining still present when input shaft is turned. Hey everyone! Just went out yesterday and picked me up a 138k original miles rust free 1994 stepside!
Why are the tail lights on my Chevy 1500 not working?
My 1994 chevy 1500 brake lights, head lights, front parking lights and front and rear turn signals work……TAIL LIGHTS do NOT work…..have checked fuses and bulbs…..What could the problem be??? If you have checked to be sure there is 12V to the lights check further to be sure there is a solid ground path. 42 people found this helpful.
How can I tell if my tail lights have a fuse?
When you have located the fuse for the tail lights use a fuse tester to check the connection. If the tester lights up – your fuse is functioning fine. If it does not light up then, replace the fuse with another of the similar amperage and size. In many instances, you can see the break in the metal strip of the fuse.
What to do if your tail light is not working?
The use of flashlight can help you identify the tail light fuse. After identifying the right fuse, you need to remove and inspect it. When the metal found inside the fuse is intact, the fuse is okay. However, a broken wire indicates that the wick is faulty.
https://www.youtube.com/watch?v=nR4m6GvVGH0
Why is my turn signal not working on my GM Truck?
“No power coming out of BCM for turn signal-tested-found circuit 1334 yellow & black wire shorted to ground-found short located in underhood fuse block-replaced underhood fuse block.” My cost for repair: $600. However, a few weeks later, the left rear turn signal stopped working again. I took it back to the dealer.
Why does my turn signal light not blink?
I have a problem like this on my 2008 Chevy Suburban. Left rear turn signal light does not blink when using the turn signal. The light doesn’t blink when I turn on the hazard flasher. The bulb is good. The fuses are good. I took it to the dealer. They tried replacing the Body Control Module (BCM) but that didn’t fix it.
Why is my turn signal not working on my 1999 Yukon?
1999 Yukon; rear turn signal not working. Front working fine, fast blinking indicator, was not the bulbs, was not a loose wiring harness, or dirty connectors (although all worth a quick try) * The board that the 3 lightbulbs plug into, goes bad ! Super easy fix ]
Mostly starts past 30mph. Transmission is off the Suburban now. Whining still present when input shaft is turned. Hey everyone! Just went out yesterday and picked me up a 138k original miles rust free 1994 stepside!
Why does the ctsy fuse keep blowing on my GMC Yukon?
The Ctsy Fuse feeds all of the interior lamps in the truck. As you mentioned it does the vanity mirror lights to the glove compartment light. This is a bit unusual because the circuits are wired “HOT”. Which means that all of the lights have power to them all the time and they are turned on by grounding them.
Why does my ctsy fuse keep blowing backwards?
Which means that all of the lights have power to them all the time and they are turned on by grounding them. Normal circuits are switched on by turning on the +12. This one is backwards.
What is the fuse box diagram for a Chevy truck?
Chevy Truck Fuse Block Diagrams – Chuck’s Chevy Truck Pages Chevrolet truck fuse box diagrams. 1973 – 1979 fuse box diagram. !980 – 1987 fuse box diagram. Great resource if the lettering is worn off yours
Why does my Check Engine Light never come on?
The C/K line includes pickup trucks, medium-duty, and heavy trucks. When I turn the ignition on, all of the lights on the dash turn on and then go off. But the check engine light never turns on. How do I make it come on?
What is the wiring diagram on a 1982 Chevy truck?
Most recently, I picked up a GM 1982 Light Duty Truck Factory Service Manual, which includes a full wiring diagram. I won the bid for $17.00. Back in 1992, at a local swap meet, I paid $30 for the same GM factory Service manual for my 77. The older manuals didn’t include wiring. I currently have a bid in myself on a 1977 GM Factory Wiring Manual.
Why does my turn signal fuse keep blowing?
Checking this with an ohm meter proved that indeed that was the case. Most of the time, a bad back-up light switch will either stay stuck, and lights stay on all the time… or else it won’t work at all, and lights stay off. But this switch had the unique problem (to me, anyway) of grounding out the 12 volt feed when you put the truck in reverse.
The C/K line includes pickup trucks, medium-duty, and heavy trucks. When I turn the ignition on, all of the lights on the dash turn on and then go off. But the check engine light never turns on. How do I make it come on?
Where are the fuses on a Honda Odyssey?
I checked every fuse in the fuse box under the dash. I also tested the wires coming off the small plug of the alternator and checked every fuse including the hidden 10amp one at the top of the fuse box, under the dash.
