What should I do if my twine on my baler is not working?
What should I do if my twine on my baler is not working?
Adjust tucker finger. finger did not pick up needle twine. (Check baler manual) 2. Needle did not place twine 2. Adjust needle. into twine disc. (Check baler manual) 3. Hay dogs did not function properly. 3. Check to see if hay dogs are stuck or have broken a spring. A Simple Knot in the Twine End
What’s the best way to remove a retaining pin on a baler?
Take a 9/16-inch wrench on the nut at the bottom of the pinion shaft and rotate back and forth to see how much wear is present. 5. To remove the billhook pinion, raise the knotter frame up until the billhook roller is at the 7 o’clock position. Take a 3/16-inch pin punch and drive out the retaining pin.
Can a New Holland square baler tie a bale?
New Holland 268 square baler wouldn’t tie a bale. The knotters would get a bunch of twine wrapped up and it would be a mess. It’s an easy fix in this case Loading…
What to do if your hay baler is stuck?
Check to see if hay dogs are stuck or have broken a spring. A Simple Knot in the Twine End POSSIBLE CAUSE REMEDY Tw ine pulled out of the twine disc. Tighten twine disc. Decrease twine box tension. Check for objects that might obstruct the twine. Tw ine in the Knot is Ragged
Adjust tucker finger. finger did not pick up needle twine. (Check baler manual) 2. Needle did not place twine 2. Adjust needle. into twine disc. (Check baler manual) 3. Hay dogs did not function properly. 3. Check to see if hay dogs are stuck or have broken a spring. A Simple Knot in the Twine End
Take a 9/16-inch wrench on the nut at the bottom of the pinion shaft and rotate back and forth to see how much wear is present. 5. To remove the billhook pinion, raise the knotter frame up until the billhook roller is at the 7 o’clock position. Take a 3/16-inch pin punch and drive out the retaining pin.
Check to see if hay dogs are stuck or have broken a spring. A Simple Knot in the Twine End POSSIBLE CAUSE REMEDY Tw ine pulled out of the twine disc. Tighten twine disc. Decrease twine box tension. Check for objects that might obstruct the twine. Tw ine in the Knot is Ragged
How to tighten twine tie Baler knotters spring?
Tighten the twine holder spring bolt and turn. Decrease the billhook cam tension by loosening the spring nut; turn and test it. It might be insufficient stripper throw. If so, re-adjust as needed to provide ½-inch to ⅝-inch clearance between the stripper arm flange and billhook at the end of stripper arm travel.
