What should I do if my Chevy Malibu shift knob is stuck?

I replaced the ignition switch and that didn’t help. Some one mentioned that the shift knob has linkage that needs to completely return in order for a cable to pull a lock in the ignition switch that releases the key. It is called the Chevrolet Malibu Shift Interlock Solenoid. Once I replaced that part, everything worked fine.

What’s the Chevy Malibu shift interlock solenoid called?

It is called the Chevrolet Malibu Shift Interlock Solenoid. Once I replaced that part, everything worked fine. I put the old key cylinder and ignition switch back in and plan to try returning the parts I bought.

Where are the keys on a 2010 Malibu?

for a 2010 Malibu, there is a small plastic panel on the passenger side that is removable without tools. Once off, you can see the cable running from the shifter to the key switch. The plastic piece which attaches to the shifter had been stuck out of proper position. Once I jiggled the wire and moved the plastic piece, my keys came right out.

What happens when you remove transmission shift cable?

Dealer (Momentum Chevrolet in San Jose) claimed “we didn’t touch it, we won’t fix it (unless you pay us)”. So… What happened is that when they repaired the transmission shift cable, they removed the wiring harness.

What to do about a stuck key on a Malibu?

Stuck key/ sticky shifter release – solution! Not open for further replies. 2005 Malibu Maxx. I would shift the car to park, key would not come out. Would have wiggle the key excessively until it would click over further counter clockwise and then release. WD 40 into the cylinder did not help at all.

What to do when your gear shifter is stuck?

The raw cable is exposed before going into the outer cable. I could see that the cable was getting hung up and not releasing smoothly. Put a little WD 40 where the cable/ wire goes into the outer cable. Now the key releases perfectly, and the release for the gear shifter is much better.

Why does my Chevy Malibu not turn over?

My 2001 Malibu would not crank. It would turn over but would not crank, as if it wasn’t getting fuel. I had this issue about a month ago and my friend changed plugs and wires, checked compression (good), and fuel system (good).

How to reset the anti theft system on a Chevy Malibu?

55 people found this helpful. If starter cranks engine but it won’t start and “anti-theft system” light on dash is blinking then the anti-theft system is preventing fuel from reaching the engine. Just turn the ignition key to on position and wait for approx. 10 minutes and the blinking anti-theft will go off.

What kind of interlock does a Chevy Malibu use?

It turned out to be the Chevrolet Malibu Shift Interlock Solenoid. I replaced that and everything worked again. it was a 2003 car with over 200,000 miles. Not open for further replies. Did you find the recommended reading relevant to this discussion?

How to fix your Chevy Malibu shift cable?

The Easiest way to fix your Chevrolet Malibu shift cable! – YouTube The Easiest way to fix your Chevrolet Malibu shift cable! If playback doesn’t begin shortly, try restarting your device.

What to do if your shifter is stuck?

WD 40 into the cylinder did not help at all. Also the button you squeeze to pull the shifter out of park was very sticky. I found a TSB on the issue which required pulling out the center console and adjusting the park lock cable mechanism, which is cable that goes into the side of the ignition cylinder.

Why does my Chevy Malibu say shift to Park?

Getting a “SHIFT TO PARK” warning message even though car is actually in park. Dealership states this is a known issue across multiple GM models but GM refuses to accept responsibility. Repair will cost $750.00 dollars and is not covered under an extended powertrain warranty. GM says this is an electronic part and is not part of the powertrain.

Do you have to shift into Park on a Chevy Malibu?

Unfortunately the temporary fixes have eventually failed in days weeks months for just about anyone who’s tried them. Replacement as a DIY or dealer under warranty is needed. My message board tells me to shift into park, after I have and turned the vehicle off. I then have to turn the lights off manually.

Where is the shift lock solenoid located on a Chevy Malibu?

• The automatic transmission shift lock solenoid (serviced as the automatic transmission shift lock actuator), as well as the body control module (BCM) and the engine control module (ECM). The shift lock solenoid is located within the floor shift control assembly with vehicles equipped with floor shift.

Can a shift lever be removed from Park?

• The shift lever must not move from park unless the key is in the ON position. If the lever can be removed from park with the key in the OFF position, adjust or repair the park lock cable. While using a small screwdriver to release the adjuster lock tang, rotate the threaded cable adjuster (1) until 3 threads are showing.

What makes a Chevy truck shift out of Park?

The de-energized solenoid releases the mechanical lock allowing the driver to move the shift lever out of the PARK position. When the transmission is out of the PARK position, the shift lock control solenoid remains de-energized.