What is ther code for 2001 Ford F250?
What is ther code for 2001 Ford F250?
Ther is also a code of B1323 Door ajar lamp circuit malfunction, but the door ajar has been coming on for a long time and the dome light bulb is out, so I haven’t worried about that Ford Mechanic: AJ, Ford Technician replied 12 years ago
Where are the P and B codes on a Ford Focus?
The P codes are powertrain codes.And B codes are body codes.The chime switch is on the ingition cylinder.If you turn the key in the run position there is a small button on the bottom of the ingition cylinder you have to press to remove the cylinder.Those codes should not cause any driveability problems or trens shift problems. AJ, Ford Technician
What does the OBD code B1352 stand for?
OBD II fault code B1352 is a manufacturer specific code that is defined by carmakers Ford and Jaguar as “Ignition key-in – circuit failure”, and is set when the PCM (Powertrain Control Module) detects a malfunction or general failure in circuits that are active when the ignition is switched off,…
Can a Ford Escape 2.0L ignition key be B1352?
Hi Ford Mechanics I have a 2003 escape 2.0L with a P01602 PATS received Invalid Format of Key code from Ignition Key Transponder. and a B1352 Ignition Key In Circuit Failure and I need the repair Info… read more Ron ASE Certified Technician Vocational, Technical or Trade Scho
What to look for in a Ford B1352 code?
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the B1352 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city.
Ther is also a code of B1323 Door ajar lamp circuit malfunction, but the door ajar has been coming on for a long time and the dome light bulb is out, so I haven’t worried about that Ford Mechanic: AJ, Ford Technician replied 12 years ago
The P codes are powertrain codes.And B codes are body codes.The chime switch is on the ingition cylinder.If you turn the key in the run position there is a small button on the bottom of the ingition cylinder you have to press to remove the cylinder.Those codes should not cause any driveability problems or trens shift problems. AJ, Ford Technician
Where is the ” key in ” wire on a Ford B1352?
Before I was thinking it was from a previous brake controller, but now not sure. The “All Data” wiring diagram 59-1 show the “Key-In” wire to be Black/Pink but thought it could be wrong. There is also a Blue/Yellow wire cut in two, can see both ends, close to front, over by OBD connector.
