What is the Allison MD 3060 transmission troubleshooting manual?

This manual provides troubleshooting information for Allison Transmission Division, MD/HD/B Series Transmissions. Service Manuals SM2148EN and SM2457EN, and Parts Catalogs PC2150EN and PC2456EN may be used in conjunction with this manual.

What happens to the PBD on an Allison MD3060?

Without power and ground to the noted terminals the display will not illuminate and unfortunately the engine will not start, as this is also your Netural Safety Device. Since the Transmission Electronic Control (ECU) is responsible for powering up the PBD my attention was then focused on this unit and its inputs.

How to calculate fluid change in Allison Transmission?

If a fluid analysis program is not available, use the Fluid + Filter Calculator below to determine your fluid change information. Is the prognostic feature enabled for your transmission? Consult your Operator’s Manual for how to determine if Prognostics is turned on.

Are there any problems with the Allison 2000 transmission?

Greetings to all. I work at a fleet of around 450 buses and we have about 150 buses with the Allison 2000 series transmission. We are starting to have numerous problems with these transmissions not going in reverse and defaulting and also some will not upshift.

Can a service procedure not be recommended by Allison Transmission?

Accordingly, ANYONE WHO USES A SERVICE PROCEDURE OR TOOL WHICH IS NOT RECOMMENDED BY ALLISON TRANSMISSION MUST ﬁrst be thoroughly satisﬁed that neither personal safety nor equipment safety will be jeopardized by the service proce- dures used.

How does the Allison automatic shift selector work?

The electronic control system of your Allison Automatic is programmed to inform the operator of a problem with the transmission system and automatically alert the operator. When the Electronic Control Unit (ECU) detects a problem condition, the ECU: – Restricts shifting – Illuminates the CHECk TRANS* light on the instrument panel

Where can I get parts for my shift selector?

Repair parts for the internal wiring harness and for wiring harness components attached to the shift selector will be available through the Allison Transmission Parts Distribution Center (PDC). Use the P/N from your appropriate parts catalog or from Appendix E in this manual.

Which is the Allison Transmission Division troubleshooting manual?

What kind of fluid does an Allison Transmission use?

Allison Transmissions currently only recommends the use of TES 295/468 fluids in all transmissions. this is synthetic based fluid and available under the following brand names/suppliers: Castrol: Transysnd, BP Lubricants: Autran Syn 295, Cognis Corp: Em Gard 2805, International Truck: Fleetrite Synth.ATF.

What kind of wiring harness does Allison Transmission use?

NOTE: Allison Transmission is providing for service of WTEC II wiring harnesses and wiring harness components as follows: (See Service Information Letter 1-WT-97 for further information.)

Is there a troubleshooting manual for the Allison 3000?

This manual provides troubleshooting information for the 3000 and 4000 Product Families Transmissions. Service Manuals SM4013EN and SM4014EN, plus Parts Catalogs PC2150EN and PC2456EN may be used in conjunction with this manual. This manual includes: Description of the 3000 and 4000 Product Families Allison 4 TH

What kind of horse is an Allison md3060p?

MD3060P is my model shifts kinda slow, and is completly electronic, but runs off its own isolated computer, and power supply. easy good for 275 (truck rated HP) horse in stock trim. shoudl be a good use for you but it is HUGE, and parts are big $$ for it…. not to mention a used one usually goes for big $$ itself with lots of miles.

Is the WTEC III controller a 6 speed transmission?

The WTEC III controller had limited IO so depending on what vocation package you were trying to run you may be limited to a 5 speed transmission rather than being able to use it as a 6 speed.