How to replace the intake manifold in a Dodge Ram?

Part 1 Intake manifold Dodge Ram 1500 4 .7 – YouTube tips & a visual on how to replace your intake manifold and why I replaced it tips & a visual on how to replace your intake manifold and why I replaced it

Why do you need a plenum repair plate on a Dodge truck?

A plenum repair plate replaces a failed factory stamped steel plate on all Dodge 1992-2003 5.2 and 5.9 liter V8 Engines. It allows the plenum gasket to stay in place for a good seal that will last the lifetime of the truck.

What causes the intake gasket to fail on an aluminum engine?

When the engine heats up to operating temperature, the aluminum intake manifold expands differently than the steel stamped factory plenum plate and this will cause the gasket to fail by moving out from in between the plate and the manifold.

What happens if your factory plenum plate fails?

If you have a sudden loss of gas mileage, excessive oil consumption, rough running or low power, your Factory Plenum Plate Gasket may have failed. In addition to the above symptoms, it can cause O2 Sensors to fail, it can cause detonation (pinging) and ruin your catalytic converter.

Can a plenumrepair plate be installed on a Dodge Ram?

It is precision water jet cut and ready to install on your Dodge Ram V8 truck. This plate has been installed in over 1200 Dodge 5.2 and 5.9 Liter engines with great results, this is a direct bolt on replacement for the stamped steel factory plate.

What is the plenum gasket on a Dodge Magnum?

“Plenum Gasket, what is it, where is it and what should I do about it” applies to 3.9, 5.2, 5.9 magnum motors. When Dodge made the intake for these motors they made it in two pieces, cast aluminum for the top and a stamped steel plate for the bottom, with of course a gasket between the two.

Can a faulty intake manifold cause engine overheating?

Apart from sealing engine vacuum, certain designs will also seal engine coolant. When the intake manifold gaskets have an issue, they can cause drivability problems and even engine overheating. Usually a faulty intake manifold gasket will produce a few symptoms that can alert the driver of a potential issue. 1.

What causes intake manifold gaskets to wear out?

As the vehicle acquires mileage, the intake manifold gaskets may wear out and eventually leak. This can cause major performance issues, as the intake manifold gaskets seal engine vacuum and pressure.

Can a leak in the intake manifold cause a bad smell?

Some intake manifold gaskets also seal engine coolant, and if the gasket wears out it may lead to a coolant leak. This may produce a distinct coolant smell, along with steam, and drips or puddles of coolant underneath the vehicle. Coolant leaks should be addressed as soon as possible, in order to prevent them from becoming a greater issue. 3.

What kind of engine does a Dodge Ram use?

This article applies to the Dodge Ram 3rd Generation (2002-2008). The Dodge Ram uses several different engines in its third generation model years. The 3.7 liter V6 and 4.7 liter V8 removal procedures are similar.

When did the Dodge Ram service manual come out?

A download Dodge Ram Service Manual is a digitally delivered handbook of instructions for learning how to fix or mend the full-size pickup back to working order. Dodge has been making pickup trucks since the early 1900s, but it wasn’t until 1981 that they adopted the name Ram.

How much does it cost to change the oil on a Dodge Ram?

The average cost to change the oil on a Dodge Ram is over one hundred dollars and is required more often if the vehicle is used in extreme conditions. Certain repairs can run thousands and can be inflated far above that by dealers or service stations.

What kind of engine is in Dodge Ram 1500?

The longest time of using the PowerTech V8 4.7L engine was on the Dodge Ram 1500 – until the 2013 model year. Chrysler replaced this 4.7-liter V8 power unit by a more technical innovative 3.6 V6 Pentastar and modern Hemi V8 engines.

What are the problems with a 2002 Dodge Ram 1500?

Lighting issues are common in Dodge Ram trucks and are one of the most frequently-cited 2002 Dodge Ram 1500 electrical problems specifically. Owners find that their headlights, taillights or turn signals suddenly stop working, causing irritation at best and a safety hazard at worst.

Is there a problem with my Ram 1500?

Multiple coolant leaks are one of the more common 2015 RAM 1500 problems, as well as affecting model years 2009-2014. Many owners report that the leaking is strange because it’s difficult to locate even with a pressure test and that the leak only occurs when the engine is cold.

What kind of truck is the Dodge Ram?

All cars and minivans retained the Dodge nameplate, but the Dodge Ram and Dodge Dakota trucks became RAM trucks. This article focuses on the full size pickup formerly known as the Dodge Ram pickup and now known as the RAM pickup.

What causes a Dodge Ram 1500 to Misfit?

Bad head gaskets, worn piston rings, bad valves and worn cylinder walls are all culprits. Damaged or broken rocker arms, broken valve springs, and worn camshaft lobes or lifters are also reasons for mechanical misfiring. Most of these failures will be accompanied by some form of internal engine noise.

What causes a ticking sound in a Dodge Ram 1500?

A bad or failing manifold leads to decreased engine performance, and broken manifold bolts are common in Dodge Ram 1500s of all ages. The most common symptom of broken or degraded bolts is a ticking sound on cold starts, frequently heard from the passenger side of the truck.

What happens if you have a blown head gasket?

If you’ve got multiple signs of a blown head gasket, you can run the risk of overheating your engine due to a low coolant level as mentioned above. Similarly, driving with coolant flowing into your combustion chamber will eventually allow coolant into your engine oil.

Is there a problem with my Dodge Ram head gasket?

I have no smell of burning coolant anywhere in or around the truck. The P0307 code came on last week after a rough start. cylinder 7 misfire. The Idle smoothed out but the truck still feels like it is missing a little.

What was the damage to my Dodge Ram?

Total for the job was $1900. Hopefully all is good now. Got similar issue, 94,000 on my 2005 ram with the 4.7 magnum now, overheated last year due to a blown radiator, had a small head gasket leak. Water pump went bad shortly after. No coolant in oil.

What happens if you have a bad head gasket?

Driving with a bad head gasket is hazardous to the engine, and may even be impossible. A failing head gasket typically will lead to your engine overheating and will eventually ruin the engine block, cylinder head, or both. A car with a blown or leaking head gasket should both be towed to a repair facility.

How does the head gasket in an engine work?

The head gasket maintains a seal between the engine block and cylinder head. It prevents oil, coolant and combustion gases from escaping the engine. How does the head gasket work? Most engines have two major components: the engine block and the cylinder head. These two halves must seal to one another and act as one piece, or the engine will fail.

Where to get parts for a Dodge Ram 2500?

OEM Dodge Ram 2500 Parts. Genuine Dodge Ram 2500 Parts from Factory Chrysler Parts in Bartow, FL. Dodge OEM Ram 2500 Parts from Thunder CDJR. Genuine Dodge parts are the smart choice for repair, maintenance, or upgrade of your Dodge Ram 2500 .

What do you need to know about the Dodge Ram 2500?

Among serious truck drivers and buyers, the Dodge Ram 2500 is known as the Hemi-powered master of towing and performance. A truck as unique as the Dodge Ram 2500 demands custom-fit parts and accessories, and you’ll find of list of just such parts below.

What’s the lowest price for Dodge Ram parts?

We are your low price leader for OEM Dodge Ram 2500 parts. OEM Dodge parts are manufactured by Dodge to maximize the performance of Dodge Ram 2500 vehicles and provide the certainty that the repair will be done right the first time. Parts that fit. Parts that perform.

Are there any aftermarket parts for Dodge Ram 2500?

At 4WP, we’re here to make your dream truck design into a reality by offering you access to hundreds of parts for your Ram 2500, all designed to fit both your truck and your lifestyle perfectly. It’s natural to be nervous when making a big purchase online.

How to remove intake manifold in Ram 1500?

But taking that that fuel rail off along with the turbo elbow, those will be you’re great nemesis. Had to rig up a torx bit and a vise grip to pull that fuel rail off. Like I said not for the weak. But I’m surprised it’s not as sooty as other pictures I’ve seen.

Can you order Ram Truck Parts from Mopar?

More importantly, however, we sell only genuine OEM parts, straight from Mopar, designed to be compatible specifically with the Ram Truck pickup or van you love to drive. You won’t get the same fit and finish from the aftermarket. Better yet, if you’re looking to order auto parts online, we’ve made it easy.

Is it safe to Buy Dodge Ram parts online?

It’s natural to be nervous when making a big purchase online. However, 4WP seeks to eliminate any uncertainty around buying truck parts online by swearing to only sell OEM parts from leading manufacturers, which ensures you’re getting a quality product with each and every purchase without fail.

How to replace the intake manifold in a Dodge Ram?