How to replace heater core, and if I have to remove dash?

Drain engine coolant. Disconnect heater hoses from heater unit. Remove instrument panel assembly. Disconnect blower resistor connector. Remove heater unit-to-blower duct. Remove instrument panel stay. Remove heater unit. Remove heater unit-to-blower duct. Remove mode control case, but DO NOT remove linkage unit yet. See Fig. 7 .

How to remove the dash from a hot water heater?

Remove negative battery cable. Drain engine coolant. Disconnect heater hoses from heater unit. Remove instrument panel assembly. Disconnect blower resistor connector. Remove heater unit-to-blower duct. Remove instrument panel stay. Remove heater unit. Remove heater unit-to-blower duct. Remove mode control case, but DO NOT remove linkage unit yet.

How to remove a leaking aircon heater core?

1. Remove Glove box – There are 4 screws at the top and 2 plastic tabs at the bottom of it where it hinges to remove. 2. Remove plastic backing to glove box which hides aircon evaporator thingy – I think there is just 2 screws and then a decent tug should do.

Is there a way to replace the dash on a air conditioner?

There are short cuts for the heater and air but the dash has to come out half way at least. The cover does not have to be taken off of the frame though. But it is a good time to replace it if needed. yeah there is no way to replace other than pulling the dash. All together its about a 5-6 hour job.

How to remove a heater core in a garage?

Regular Phillips head screwdriver Small flat tip screwdriver Metric wrench (for the battery negative terminal) Removal Disconnect the battery negative terminal. Drain the coolant system. Remove the glove box. Disconnect the rubber hose for the thermometer (if equipped) and also remove the plastic air duct.

How do you remove the core from a hot water heater?

Disconnect the battery negative terminal. Drain the coolant system. Remove the glove box. Disconnect the rubber hose for the thermometer (if equipped) and also remove the plastic air duct. These two plastic duct pieces must now be removed. The lower piece is secured with one screw.

How to replace heater core, and if I have to remove dash?