How much torque can a g56 handle?

Registered. From what I have read the manufacturer rates the g56 up to 600 ft lbs of torque which who knows if that’s accurate or not. From personal experience though, mine is a 2015 and its fully deleted with anarchy tunes. On the 100hp tune in 5th and 6th gear if I hammer on it the clutch slips pretty good.

Are there any problems with the 48RE torque converter?

The 48RE torque converter is tested for leaks, lockup, concentricity, and balance, Upgrades, including billet converter cover with machined mounting pads, surpass OE requirements, thereby eliminating the possibility of front seal leaks, premature bushing wear. and vibration.

When did the 48RE Transmission come out for Dodge Ram?

The 48RE is a 4 speed automatic transmission, it was manufactured between the years 2002 to 2010. It was a direct replacement for the Dodge Ram 2500 and 3500 series trucks.

Are there any rear wheel drive Torqueflite transmissions?

Rear-wheel drive transmissions. 1 A466. The original TorqueFlite was designated A466, with a cast iron case, separate iron converter housing, and no parking pawl. 2 A727 (36RH/37RH) 3 A904 (30RH)

How to know the 42-48re series transmissions?

Getting to Know the 42-48RE Series Transmissions part 1 222dave.indd 222dave.indd 22 66/8/06 10:18:40 AM/8/06 10:18:40 AM GM Transmissions: With the strength of GM squarely behind you. •New toll-free Powertrain Contact Center for all your questions

How does the BD performance 48RE Transmission work?

Inside each transmission is a revised valve body that achieves up to 80% higher clutch apply pressures over the stock unit and up to 50% over the competitors with the increase starting at much lower engine rpm’s and at lighter throttle pedal position movement. Light throttle shift firmness is also maintained at these higher apply pressures.

What is the governor pressure on a 42-48re transmission?

The governor pressure control sys- tem on the 42-48RE transmissions is a closed loop feedback system; a sys- tem of sense and adjust. Here’s what that means: The computer determines what governor pressure should be, based on vehicle speed. At, say, 25 MPH, the computer knows that governor pres- sure should be right around 25 PSI.

What makes a TorqueFlite transmission different from other transmissions?

It still uses governor pressure to move the shift valves, just like the old Torqueflite transmissions that came before it. Only 4th gear is electronically controlled. What makes it unique is that it doesn’t have a mechanical governor. Instead, it uses a solenoid to control governor pressure.

How much torque can a g56 handle?