How many volts should alternator?

How many volts should alternator?

A good alternator should put out between **13.5-14.5 volts. Stress test the alternator – Place a load on the alternator by turning on the headlights, the radio and the air conditioning. The voltage should remain high with these circuits on.

What should the voltage be on a bat alternator?

Measure the voltage across the battery and the big bat alternator terminal to alternator case. There are two things that you are looking for. The charging voltage should be between 13.9v to 14.4v. Also the voltage at the battery and the voltage at the alternator should be within 0.5v of each other.

What to do if your alternator has low voltage?

Put the black multimeter probe on the negative battery terminal (if possible dig it into the battery post, not the terminal). Put the red probe on the alternator case. Your looking for the voltage to be below about 0.5v. If the voltage is higher than that examine all the negative cabling for problems. Preform the same test with the positive side.

How can I tell if I have an alternator problem?

To differentiate an alternator problem from the battery, you will need to use a voltmeter to check for voltage. First, turn off the engine and check the battery voltage. A fully charged battery should have a reading of 12.65 volts. Next, turn on the engine and recheck the voltage. You should have a reading of 13.5 to 14.5 volts.

Can a dead voltage regulator be replaced in an alternator?

At least a dead voltage regulator in the alternator. The voltage regulator can be easily replaced without removing the alternator most of the time, and usually is cheap so worth a try. Nevertheless, you should definitely clean those connectors and terminals every now and then. – galingong Feb 15 ’17 at 9:25

Can a battery voltage test be done on an alternator?

One test is not enough if you are diagnosing a charging system problem. All too often, the alternator is condemned as the source of the problem if only battery voltage is present with the engine running. If this is the case, it only means that the alternator is not charging, but does not reveal why.

What to do when you install a new alternator?

When a new alternator is installed, check the battery voltage and use a battery charger to bring the battery up to full charge before you return the vehicle to your customer. Also, start the engine and use your DVOM to check the charging output of the alternator. Don’t assume everything is working OK just because you bolted in a new alternator.

Is it normal for an alternator to not charge?

Still, it’s perfectly normal for others to see the alternator not charge at all intermittently. One test is not enough if you are diagnosing a charging system problem. All too often, the alternator is condemned as the source of the problem if only battery voltage is present with the engine running.

What should the voltage drop be on an alternator?

Ideally, the voltage drop across any connection should be zero or less than 0.1 volts. Poor ground connections are an often-overlooked cause of low charging output and alternator failure.