How do you reset the TPMs on a Chevy Silverado?

The horn will sound twice to indicate the TPMS receiver is ready, and the TIRE LEARNING ACTIVE message will display. If your vehicle does not have the DIC buttons, press and hold the trip odometer reset stem until the horn chirps twice and the TIRE LEARNING ACTIVE message is displayed.

How to relearn the throttle on a Chevy Silverado?

1. Remove negative battery cable for 20 minutes to reset all DTCs. 2. Start engine, run in park for 3 minutes -Engine starts at about 1200rpm, then slowly idles down to 800 rpm and back up to a steady 1000rpm 3. Remove key for 60 seconds 4.

What do I need to Reset my Chevy Silverado computer?

While doing the process of rebooting the computer, you will need the OBD II car code reader. For noting down the code, you may need a pen and a piece of paper. While buying and resetting your Chevy Silverado’s computer, there are chances that so many questions come into your mind.

How to reset a Cadillac TPMS in relearn mode?

1. Inflate all tires to the pressure listed on the placard. 2. Turn ignition to the ON/RUN position with the engine OFF (not the ACC position). 3. Turn the headlight switch from OFF to parking lamps 4 times within five seconds. The horn sounds twice to signal the receiver is in relearn mode.

Where is the TPMS reset button on a Chevy Silverado?

Press and HOLD in the TPMS RESET button (located under the steering wheel) until the TIRE PRESSURE light flashes 3 times then release. Start the vehicle but give it about 20 mins or so to completely reprogram the system.

Where is the reset button on a Chevy Silverado?

Press the 2nd button located to the LEFT of the instrument cluster next to the vent. Until you see “Press the To Relearn The Tire System”. Press the 3rd button located in the same area.

How to reset tire pressure on Chevy Silverado?

Starting with the left front tire, hold the antenna of the J-46079 against the tire sidewall close to the wheel rim at the valve stem location then press and release the activate button and wait for a horn chirp, or increase/decrease the tire pressure for 8-10 seconds then wait for a horn chirp.