How do you change a green temp sensor?

How do you change a green temp sensor?

Green temp sensor with new seal and new clip. G12 and water to top up. Thick skin….. Take the dip stick out and then remove the engine cover with a 10 mm socket. Unclip bost hose on the upper top left side and pull to one side.

What did the thermostat change on the Audi TT?

Thermostat and Temperature Sensor Changed on the Audi TT! – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.

Where is the coolant temp sensor on a 1.9 TDI?

Locate the temp sensor, on the 1.9 tdi its just under the bost hose on theleft hand side of the engine, it will have 4 wires on a connector on the back of it. Remove expansion tank cap. Remove the sender connector from the sensor.

Where is the temp sensor on a Honda Accord?

Take the dip stick out and then remove the engine cover with a 10 mm socket. Unclip bost hose on the upper top left side and pull to one side. Locate the temp sensor, on the 1.9 tdi its just under the bost hose on theleft hand side of the engine, it will have 4 wires on a connector on the back of it.

Is the thermostat failing or sensor or other?

But, the temp gauge shows cold and the engine didn’t seem terribly hot. Oh, and the fan is kicking on which it rarely does otherwise. Which do I believe?

How old is the sensor on my Dorman thermostat?

It must be electronic somehow. In addition, I can see that the Dorman thermostat housing/thermostat I installed came with a new temp sensor already installed in the housing. So, it is only 2 weeks old. It does look like to me that the wiring for the radiator sensor goes over to where the fan wiring goes.

What kind of switch does a thermostat use?

While most newer thermostats use some form of an electrical temperature sensor, older thermostats used mechanical switches, typically a bimetallic strip with a mercury or magnetic switch. With a mercury switch, as the temperature in the room changes, the coil expands or contracts, tilting a glass bulb with mercury inside.

Why is the coolant sensor on my radiator not working?

There could be a problem in the wiring to the PCM. High resistance or a partially broken wire causing the temp sensor signal to the PCM to be skewed / inaccurate. You need to have a scanner on it to look at what the PCM is showing as the coolant temp.