Why is my shift indicator not working on my Chevy Silverado?

Chevrolet Silverado 1500 Questions – Shift indicator not working and my truck won’t turn over. Is it the ns… – CarGurus Shift indicator not working and my truck won’t turn over. Is it the nsbu switch or ignition? 2003 chevy 1500 5.3l. Just did an engine swap. no… 15 people found this helpful.

Why does my shift indicator not change from Park to drive?

The first issue is that the electronic shift position indicator in the instrument panel cluster is not accurately changing when I’m shifting. For example, I will shift from Park to Drive and the display will stay on P or move to N, then when I begin to drive the display will change from P or N to D.

Why is the gear indicator not working on my truck?

The gear shifter moves through all the gears. Engine will not crank. Nsbu is the neutral safety switch 18 people found this helpful. All other dash lights come on. When I turn the key to start all gear indicator lights go out. When I shift through gears it doesn’t show what gear I’m in just displays the gears with not box around them.

What kind of issue is my Silverado having?

The vehicle I am having issues with is a 2001 Silverado 1500 LT 5.3L 4×4. The first issue is that the electronic shift position indicator in the instrument panel cluster is not accurately changing when I’m shifting.

Why is the gear indicator not working on my Chevy Avalanche?

When I turn the key to start all gear indicator lights go out. When I shift through gears it doesn’t show what gear I’m in just displays the gears with not box around them. 63 people found this helpful. having the same problem with my 2009 chevy avalanche.

Why does my AC / heater blower not work?

My radio, windshield wipers and ac/heater fan will not work. It will however work when you turn the key all the way back or forward but not when the engine is running. Not sure if it is a fuse problem or not. It is a 2003 and has 176,xxx miles on it. It’s not a fuse problem. You probably have a bad ignition switch.

Why does my GM car say no start no crank?

How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.

What to do if your shift indicator is not working?

Engine will not crank. Nsbu is the neutral safety switch 18 people found this helpful. All other dash lights come on. When I turn the key to start all gear indicator lights go out. When I shift through gears it doesn’t show what gear I’m in just displays the gears with not box around them. 63 people found this helpful.

What are the symptoms of a bad blower motor relay?

3. Melted relay. Another more serious symptom of a problem with the blower motor relay is a burned or melted relay. Relays are exposed to high current loads and can sometimes get hot when they develop problems.

Where is the blower control switch on the dashboard?

The blower control switch on the dashboard controls the circuit flow of the blower motor to adjust the voltage from low, to medium, to medium-high, to high. When on high, the circuit bypasses the blower resistor.

How to fix a PRNDL light on a GMC Truck?

To fix this problem, remove the cluster from the vehicle. Then remove the instrument cluster housings, see the most current repair information for the vehicle you are working on. . Inspect the PC solder joints (circled area) carefully with a magnifying glass. Lookin for cracks in the solder at the top or bottom.

Is the gear shift indicator dim on my Silverado?

My gear shift indicator lights are out and odometer lights are dim on my 04 Silverado. Does anyone know what circuits to solder? Are you sure your dimmer isn’t all the way down?

How to know if your Silverado has a bad dimmer?

If you pop out the H/L switch and jumper the ref to the output and the lights come back up, you have a bad dimmer. If they don’t, check that you have 5V ref. If not, you might have bad wiring or BCM. If that’s good, check for low ref. My driver info, odometer etc. lights up good most of the time and so do the cluster bulbs.

What to do if your shift selector light is not working?

1. Disconnect the wiring connector from the original transmission mounted PNP switch. 2. Connect the new switch to the wiring connector. 3. Return to Step #4 above and observe the display as you rotate the switch. If all positions indicate properly, refer to the Correction section below.

How do I reset Transmission Control Module Chevy Silverado?

I have a 2001 Silverado. To reset my TCM I turn on the key to the on position press the gas pedal to the floor for 10 seconds and then turn the key off then release the gas pedal and wait about 5 minutes to restart the engine. I have a 1999 Chevy 1500 I rebuilt the transmission so when I put it in drive its like it take off in high gear.

How to reset the oil change light on a 2001 Chevy Silverado?

Insert your key into the 2001 Chevy Silverado ignition. Turn your key two clicks forward into the RUN position. Verify that your dashboard lights, radio and odometer turn on. Your 2001 Chevy Silverado engine should not start. Push and release the accelerator pedal fully three times within five seconds while monitoring the dashboard lights.

When do the reverse lights come on on silveradosierra?

@SilverSurfer – No they still don’t come on, they only come on when shifting from below R (N-1) up to R. Going from D to R the reverse lights never come on. pnp then. Test light time. Thank you, I had a feeling. Powered by phpBB © phpBB Group.

Where is the shift selector inticator light located?

If not, inspect the serial data circuit, CKT 2470 (Yellow wire), between the TCM and Splice Pack 205. Specifically inspect connector C106, a five terminal connector located below the left side underhood bussed electrical center, directly beneath the red battery cable terminal connection.

Why does my GMC Sierra 1500 not shift gears?

GMC Sierra 1500 Questions – Speedometer doesn’t work and transmission doesn’t shift gears. – CarGurus.ca Speedometer doesn’t work and transmission doesn’t shift gears. The speedometer stays at 0 all the time. When the transmission is in drive it won’t come out of 1st gear.

Is the GMC Duramax Trans won’t shift?

Enter your ride HERE to be a part of this months Ride of the Month Challenge! Alright guys I’ve got an 04.5 LLY and after sitting for 2 or 3 days went to drive it and it clunks real hard into reverse and drive.

Where is the shift indicator on a check transmission?

Average rating from 6 customers who received a Check Transmission System. The shift indicator is located next to the gearshift assembly. As soon as you move the vehicle into gear, the shift indicator will let you know what gear you are in.